The classification and country of origin of a tool set
No revocation or modification of this ruling appears in the Customs Bulletin issues read here (Nov 6, 2024 through Nov 18, 2026), where CBP publishes most such actions. That is not confirmation that the ruling is still in effect. Confirm its status with CBP before relying on it (ruling on CBP CROSS).
Key passages, quoted from the ruling
- The general rate of duty will be 3.9 percent ad valorem.
Ruling text
In your letter dated September 18, 2025, you requested a classification and country of origin ruling on a 90-piece tool set. Product information was submitted with your request. The item under consideration is described as a 90-piece tool set packaged in a molded plastic storage case for retail sale. You state the set will be imported fully assembled with no additional processing after importation.
The set consists of: 1 - 3/8-inch drive ratchet handle 1 - Ratchet screwdriver 1 - 6-inch lineman’s pliers 1 - 6-inch long nose pliers 1 - 6-inch slip-joint pliers 1 - 6-inch diagonal pliers 1 - 8-ounce fiberglass claw hammer 1 - Phillips #1 screwdriver 2 - Slotted screwdriver 8 - Metrix hex keys 8 - SAE hex keys 1 - 1/4-inch male to 3/4-inch female socket adapter 6 - 2-inch spring clamps 2 - 4-inch spring clamps 18 - 1/4-inch drive sockets 2 - 3/8-inch drive sockets 30 - Driver bits 3 - Bit holders 1 - 6-inch torpedo level 1 - 16-foot tape measure 1 - Plastic storage case In your request, you propose two origin scenarios.
In Scenario A, the 3/8-inch drive ratchet handle and the ratchet screwdriver will be manufactured in Vietnam, and the remaining components manufactured in China. In Scenario B, the 3/8-inch drive ratchet handle will be manufactured in Vietnam, and the remaining components will be manufactured in China. In both scenarios, the components will be consolidated and packaged for retail sale in China.
Classification Merchandise is classifiable under the Harmonized Tariff Schedule of the United States (HTSUS) in accordance with the General Rules of Interpretation (GRIs). GRI 1, HTSUS, states in part that for legal purposes, classification shall be determined according to the terms of the headings, any relative section or chapter notes and, unless otherwise required, according to the remaining GRIs taken in order.
Goods that are, prima facie, classifiable under two or more headings, are classifiable in accordance with GRI 3. The instant tool sets consist of at least two different articles that are, prima facie, classifiable in different headings. They consist of articles put up together to carry out a specific activity (i.e., maintenance and repair). Finally, the articles are put up in a manner suitable for sale directly to users without repacking.
Therefore, the set in question is within the term “goods put up in sets for retail sale.” GRI 3(b) states in part that goods put up in sets for retail sale, which cannot be classified by reference to GRI 3(a), are to be classified as if they consisted of the component which gives them their essential character. Inasmuch as no essential character can be determined, GRI 3(b) does not apply.
GRI 3(c) states that, if neither GRI 3(a) nor GRI 3(b) applies, merchandise shall be classified in the heading which occurs last in numerical order among those equally meriting consideration. In this instance, the items equally meriting consideration are the ratchet handle, ratchet screwdriver, pliers, screwdrivers, hammer, hex keys, bits, sockets, and adapter.
The text above is an excerpt. The official ruling, with its letterhead, signature and any attachments, is on CBP CROSS (N353882).