The country of origin of a heat pump
No revocation or modification of this ruling appears in the Customs Bulletin issues read here (Nov 6, 2024 through Nov 18, 2026), where CBP publishes most such actions. That is not confirmation that the ruling is still in effect. Confirm its status with CBP before relying on it (ruling on CBP CROSS).
Ruling text
In your letter dated September 29, 2025, you requested a country of origin ruling on a heat pump. A description of the assembly processes was provided in your submission. The product at issue is a Light Commercial Rooftop Unit Packaged Heat Pump, model number UL-WKR160B/MN10X-134A. The heat pump consists of a cabinet that encases an evaporator, a condenser, a compressor, a blower assembly, a reversing valve subassembly and an optional heater kit.
The heat pump, which is designed for residential or certain commercial applications, is a self-contained unit that cools spaces and provides heat by reversing the refrigeration cycle. The system is intended to be installed on rooftops or ground-level slabs. With respect to origin, the final assembly of the heat pump occurs in Thailand using components from Thailand, China and South Korea. Prior to the final assembly, various subassemblies are produced in Thailand.
Five different plates (partition, protective, cover, and condenser fixing plates), an evaporator connecting plate subassembly, three cover subassemblies and two internal plate subassemblies are formed using a stamping and a bending process. Afterwards, a sponge is installed onto the plate, and when required the subassembly is coated. The beam welded subassembly is formed by stamping sheets and welding a strip onto a sheet. Two column subassemblies are formed by stamping and bending steel plates.
Next, a strip, a pipe joint installation box and a separating plate are welded onto a plate. The subassembly is then coated, and a sponge is installed. The air duct subassembly is formed by screwing a duct reinforcement support plate, an auxiliary heating cover plate, a duct enclosure plate, a fan mounting plate, and a duct connection plate to each other. Subsequently, a sponge is installed in place. The chassis subassembly, which forms the bottom structure of the unit, is produced by stamping and bending plates.
Next, a compressor base weldment, a reinforcement plate, a crossbeam, a chassis, and a waterproof panel are aligned and fastened in position using screws. Subsequently, a condenser anti-slip pad is installed, and lastly, a fiberglass wool cover is installed. The circuit subassembly, which consists of a piston throttling valve, a suction pipe, and a four-way-valve, is produced by cutting, bending, flaring and necking copper tubes. These tubes are then welded into assemblies.
The four-way-valve is secured using self-adhesive rubber pads. The production of the heat exchange subassemblies begins by threading the side plates and fins together and the insertion of long U-tubes. After tube expansion, both components are dried in an oven. Semi-circular tubes are then welded at designated positions, and the inlet and outlet pipe assemblies are welded in place.
The completed units function as an evaporator and a condenser, which is subjected to an additional bending step after the previous welding process. The production of the electrical control box subassembly begins by coating a welded box. Once coated, a main board, a module board assembly, a gas main board, a transformer and a relay are fixed into position within the box.
The text above is an excerpt. The official ruling, with its letterhead, signature and any attachments, is on CBP CROSS (N354369).