The country of origin of a constant velocity axle
No revocation or modification of this ruling appears in the Customs Bulletin issues read here (Nov 6, 2024 through Nov 18, 2026), where CBP publishes most such actions. That is not confirmation that the ruling is still in effect. Confirm its status with CBP before relying on it (ruling on CBP CROSS).
Key passages, quoted from the ruling
- As a result, it is the opinion of this office that the country of origin of the CV axle P art Number MFG#: TO-68398BA will be Thailand for marking purposes.
Ruling text
In your letter dated September 30, 2025, you requested a country of origin ruling on a constant velocity axle (CV axle) for marking purposes. The article under consideration is a CV axle, Part Number MFG#: TO-68398BA, also known as a half shaft, which is used in passenger vehicles. The primary function of the CV axle is to transmit torque generated by the engine to the vehicle’s wheels, propelling the vehicle forward.
Since the vehicle’s suspension system and wheels need to move up and down and turn, the design of the CV axle allows them to accommodate these various movements without affecting the smooth transfer of power. The CV axle consists of an outer CV joint, intermediate shaft, inner CV joint, and accessories, such as dust boots, grease, a snap ring, nut, clamp, and C-ring.
According to the production documents submitted with your request, the outer CV joint is composed of Thai sourced housing and steel balls, and Chinese sourced inner race and cage forgings. The forgings are further machined, grinded, heat treated, shot blasted, and splined, if applicable, in Thailand into finished subcomponents of the outer CV joint. The intermediate shaft is wholly produced in Thailand.
The inner CV joint is composed of Chinese sourced housing and tripod forgings, which are machined, splined, grinded, heat treated, and coated in Thailand into identifiable subcomponents of the inner CV joint. The accessories, such as the dust boots and grease are sourced from Thailand, while the finished snap ring, nut, clamp, and C-ring are imported from China.
The final assembly of the CV axle involves pressing the tripod with the intermediate shaft, installing the snap ring, dust boots, clamp, and C-ring, greasing the outer CV joint, pressing, greasing the inner CV joint, installing it with the rest of the assembly, clamping, installing the nut, and testing and coating with the arti-rust oil.
Section 304 of the Tariff Act of 1930, as amended (19 U.S.C. 1304), provides that unless excepted, every article of foreign origin imported into the United States shall be marked in a conspicuous place as legibly, indelibly, and permanently as the nature of the article (or its container) will permit, in such a manner as to indicate to the ultimate purchaser in the United States, the English name of the country of origin of the article.
Congressional intent in enacting 19 U.S.C. 1304 was “that the ultimate purchaser should be able to know by an inspection of the marking on the imported goods the country of which the goods is the product. The evident purpose is to mark the goods so that at the time of purchase the ultimate purchaser may, by knowing where the goods were produced, be able to buy or refuse to buy them, if such marking should influence his will.” See United States v. Friedlander & Co., 27 C.C.P.A. 297, 302 (1940).
Part 134 of the U.S. Customs and Border Protection (“CBP”) Regulations (19 CFR 134) implements the country of origin marking requirements and exceptions of 19 U.S.C. 1304.
The text above is an excerpt. The official ruling, with its letterhead, signature and any attachments, is on CBP CROSS (N354393).