The tariff classification of non-destructive testing equipment from France
No revocation or modification of this ruling appears in the Customs Bulletin issues read here (Nov 6, 2024 through Nov 18, 2026), where CBP publishes most such actions. That is not confirmation that the ruling is still in effect. Confirm its status with CBP before relying on it (ruling on CBP CROSS).
Ruling text
In your letter dated October 1, 2025, you requested a tariff classification ruling. Descriptive literature was provided for our review. The items under consideration are described as non-destructive testing (NDT) equipment, which are devices designed for the inspection of metallic tubes, bars, and wires during or after the manufacturing process. The systems use physical measurement principles such as Eddy Current and Ultrasonic testing to detect surface and internal defects, inclusions, or dimensional deviations.
The Eddy Current Method includes inspection using an Eddy Current encircling or segment coil to detect short and transverse defects, as well as open welds. This method allows for the high-speed inspection of magnetic or non-magnetic products with various profiles. These coils are connected to the Eddy Current generators. The user interface of the software enables the operator to adjust Eddy Current settings, display signals, and set alarm thresholds.
The Ultrasonic Method uses a full range of Ultrasonic rotating heads. They handle tubes with diameters ranging from 4 to 250mm (0.157 to 10 inches). The Ultrasonic transducers are submerged in water while rotating at very high speed around the product as it passes through the head. Internal and external defects, including longitudinal, transverse, and oblique flaws, are detected by the multi-channel systems. The inspected defect size can be as small as 1.58 by 0.1 by 0.025mm (0.6 by 0.004 by 0.001inch).
A RotoUTscan connected to the Ultrasonic instrument, MultiUTscan, can also perform highly accurate dimensional measurements, including wall thickness (WT), inner diameter (ID), outer diameter (OD), eccentricity, and ovalization, with an accuracy of plus or minus 3m. A typical system would include test heads, electronic units, and auxiliary equipment. The test heads are equipped with encircling coils (Eddy Current) or ultrasonic probes that are positioned around or in contact with the material under test.
The electronic units are used for signal generation, acquisition, and processing. These devices analyze the response of the material to induced electromagnetic fields or ultrasonic waves. Finally, the auxiliary equipment includes devices such as electrical cabinets and mechanical supports for in-line or off-line installation.
The equipment is used in industrial environments by manufacturers of tubes, pipes, and bars to ensure product quality, compliance with standards, and detection of defects without altering or damaging the tested material. The systems do not perform destructive testing, material removal, or machining. They are exclusively designed for measurement and inspection purposes.
As you suggest in your letter, the applicable subheading for the non-destructive testing equipment will be 9031.80.8085, Harmonized Tariff Schedule of the United States (HTSUS), which provides for “Measuring or checking instruments, appliances and machines, not specified or included elsewhere in this chapter; profile projectors; parts and accessories thereof: Other instruments, appliances and machines: Other: Other.” The general rate of duty will be free.
The text above is an excerpt. The official ruling, with its letterhead, signature and any attachments, is on CBP CROSS (N354474).