The country of origin of a gear pump
No revocation or modification of this ruling appears in the Customs Bulletin issues read here (Nov 6, 2024 through Nov 18, 2026), where CBP publishes most such actions. That is not confirmation that the ruling is still in effect. Confirm its status with CBP before relying on it (ruling on CBP CROSS).
Ruling text
In your letter dated October 2, 2025, you requested a country of origin ruling on behalf of your client, Permco, Inc. A description of the assembly processes was provided in the submission. The product at issue is the 2100 series Hydraulic Gear Pump. The rotary positive displacement pump, which is used in industrial fluid power systems, transfers fluid when two gears mesh together to create suction at the pump’s inlet. The pump consists of a gear housing that sits between a shaft and covers.
Together, these housings enclose valves, a seal, gaskets, and gear units that consist of a gear on a shaft. The interlocking gear units are designed to repeatedly move fluid. With respect to origin, the final assembly of the pump occurs in the United Kingdom using components sourced from the United States and other countries, such as China, India, etc.
Prior to the final assembly, steel slugs are ground, saw cut, shaped, shaved, milled, heat treated and lapped to achieve the exact tolerances of a gear unit in the United States. Once the finished gear units are exported to the United Kingdom, the faces of the gears are stoned and subject to a deburring process. In the United Kingdom, a shaft end cover, a port end cover and a gear housing, which are either from China or India, undergo additional processing.
The shaft end cover undergoes a deburring process, sealant is applied, and a ring seal, check valves, and bearings from China or the United States are inserted into the designated bores. The port end cover undergoes a deburring process, and afterwards a ring seal and bearings from China or the United States are inserted into the cover. The housing, referred to as a gear housing, which is either from China or India, is also deburred.
The final assembly begins by inserting dowel pins and a thrust end plate into a shaft end cover. Next, the shaft ends of the gear units are inserted into the bores of the shaft end cover. A gasket seal, which is sourced from either Vietnam, China or the United States, is installed into a gear housing. Afterwards, the gear housing is placed over the shaft end cover, which is followed by the application of grease.
Subsequently, a port end cover is placed over the gear housing and is manually aligned, pressed and hammered in position. The components are then affixed in position using bolts. Lastly, the pump is labeled, inspected and finished by adding plastic caps. When determining the country of origin for purposes of applying current trade remedies under Section 301 and additional duties, the substantial transformation analysis is applicable. See, e.g., Headquarters Ruling Letter H301619, dated November 6, 2018.
The test for determining whether a substantial transformation will occur is whether an article emerges from a process with a new name, character, or use different from that possessed by the article prior to processing. See Texas Instruments Inc. v. United States, 681 F.2d 778 (C.C.P.A. 1982). This determination is based on the totality of the evidence. See National Hand Tool Corp. v. United States, 16 C.I.T. 308 (1992), aff’d, 989 F.2d 1201 (Fed. Cir. 1993).
The text above is an excerpt. The official ruling, with its letterhead, signature and any attachments, is on CBP CROSS (N354559).