The country of origin of a steering tie rod end assembly
No revocation or modification of this ruling appears in the Customs Bulletin issues read here (Nov 6, 2024 through Nov 18, 2026), where CBP publishes most such actions. That is not confirmation that the ruling is still in effect. Confirm its status with CBP before relying on it (ruling on CBP CROSS).
Key passages, quoted from the ruling
- Since the ball studs and steel rod are major components that impart the character of the entire steering tie rod assembly, the country of origin will be Thailand for marking purposes and trade remedies under Section 301 will not apply.
Ruling text
In your letter dated October 6, 2025, you requested a country of origin ruling on a steering tie rod end assembly for marking purposes and for purposes of applying trade remedies under Section 301, of the Trade Act of 1974, as amended, from China. The article under consideration has been identified as a Steering Tie Rod End Assembly, Part Number TF-NA-TREAY-01, which is an aftermarket good used in passenger vehicles. The assembly, also known as a tie rod assembly, provides directional control for vehicles.
It is made primarily of steel with plastic and rubber components and weighs approximately 5lbs. The tie rod assembly consists of ball studs, a steering rod, ball stud shell, dust cover, dust boot, cotter, pin, castle nut, and plastic seats. You state that the raw materials, steel bars, are sourced from China and shipped to Thailand for further processing. In Thailand, the steel bars undergo cutting, heat treatment, and forging, thereby become rough ball studs (RPBP-0003 and RFBP-0002) and steering rod (RFTRE-0001).
Rough ball stud RPBP-0003 then undergoes machining of the bottom side, middle section, neck section, head section, and thread rolling. Rough ball stud RFBP-0002 undergoes CNC machining, cotter pin hole drilling, detailed machining of the head section, and thread rolling. Rough steering rod RFTRE-0001 undergoes hole drilling, CNC facing, chamfering and grooving, edges cutting, and tapping and milling.
The ball stud shell forging is sourced from China and undergoes machining of the top section and the end face, finishing the inner hole, and thread rolling in Thailand. Finally, the machined ball stud shell, ball studs, and steering rod are assembled together with the cotter pin, castle nut, and plastic seats from China and dust cover and dust boot from Thailand in Thailand.
When determining the country of origin for purposes of applying current trade remedies under Section 301 and additional duties, the substantial transformation analysis is applicable. See, e.g., Headquarters Ruling Letter H301619, dated November 6, 2018. The test for determining whether a substantial transformation will occur is whether an article emerges from a process with a new name, character, or use different from that possessed by the article prior to processing.
See Texas Instruments Inc. v. United States, 681 F.2d 778 (C.C.P.A. 1982). This determination is based on the totality of the evidence. See National Hand Tool Corp. v. United States, 16 C.I.T. 308 (1992), aff’d, 989 F.2d 1201 (Fed. Cir. 1993).
Additionally, Section 304 of the Tariff Act of 1930, as amended (19 U.S.C. 1304), provides that unless excepted, every article of foreign origin imported into the United States shall be marked in a conspicuous place as legibly, indelibly, and permanently as the nature of the article (or its container) will permit, in such a manner as to indicate to the ultimate purchaser in the United States, the English name of the country of origin of the article.
Congressional intent in enacting 19 U.S.C. 1304 was “that the ultimate purchaser should be able to know by an inspection of the marking on the imported goods the country of which the goods is the product.
The text above is an excerpt. The official ruling, with its letterhead, signature and any attachments, is on CBP CROSS (N354638).