The country of origin of an audio amplifier/speaker
No revocation or modification of this ruling appears in the Customs Bulletin issues read here (Nov 6, 2024 through Nov 18, 2026), where CBP publishes most such actions. That is not confirmation that the ruling is still in effect. Confirm its status with CBP before relying on it (ruling on CBP CROSS).
Key passages, quoted from the ruling
- Therefore, since a substantial transformation does not occur as a result of the Chinese processing, the country of origin of the finished Harbinger VARI V1112 audio amplifier/speaker will be Thailand for origin and marking purposes at time of importation into the United States.
Ruling text
In your letter dated October 8, 2025, you requested a country of origin ruling on an audio amplifier/speaker assembly, on behalf of your client, Guitar Center, Inc. The item concerned is referred to as the Harbinger VARI V1112 audio amplifier/speaker. The subject amplifier/speaker is a portable sound system with advanced electronic features for amplification and sound reproduction of instruments and voice. It includes a pre-amp and sound mixer with multiple inputs to support instruments and microphones.
The Harbinger VARI V1112 audio amplifier/speaker incorporates components from various countries including Thailand and China. It will undergo manufacturing/processing in Thailand and China before being imported into the United States from China. The back panel (chassis assembly), which houses the electronics needed to provide the amplification and other functionality, is manufactured within Thailand. The chassis incorporates various printed circuit board assemblies (PCBAs), knobs, and wire/cables.
PCBAs manufactured in Thailand: Pre-Amp PCBA Power-amp PCBA Power supply PCBA Bluetooth PCBA LED PCBA The PCBAs and panels (chassis) are manufactured in Thailand. These are then sent to China where they are assembled with Chinese origin speakers into a Chinese origin enclosure. When determining the country of origin for purposes of applying current trade remedies under Section 301 and additional duties, the substantial transformation analysis is applicable.
See, e.g., Headquarters Ruling Letter H301619, dated November 6, 2018. The test for determining whether a substantial transformation will occur is whether an article emerges from a process with a new name, character, or use different from that possessed by the article prior to processing. See Texas Instruments Inc. v. United States, 681 F.2d 778 (C.C.P.A. 1982). This determination is based on the totality of the evidence.
See National Hand Tool Corp. v. United States, 16 C.I.T. 308 (1992), aff’d, 989 F.2d 1201 (Fed. Cir. 1993).
Additionally, Section 304 of the Tariff Act of 1930, as amended (19 U.S.C. 1304), provides that unless excepted, every article of foreign origin imported into the United States shall be marked in a conspicuous place as legibly, indelibly, and permanently as the nature of the article (or its container) will permit, in such a manner as to indicate to the ultimate purchaser in the United States, the English name of the country of origin of the article.
Congressional intent in enacting 19 U.S.C. 1304 was “that the ultimate purchaser should be able to know by an inspection of the marking on the imported goods the country of which the goods is the product. The evident purpose is to mark the goods so that at the time of purchase the ultimate purchaser may, by knowing where the goods were produced, be able to buy or refuse to buy them, if such marking should influence his will.” See United States v. Friedlander & Co., 27 C.C.P.A. 297, 302 (1940).
Part 134 of the U.S. Customs and Border Protection (“CBP”) Regulations (19 CFR 134) implements the country of origin marking requirements and exceptions of 19 U.S.C. 1304.
The text above is an excerpt. The official ruling, with its letterhead, signature and any attachments, is on CBP CROSS (N354778).