The country of origin of floor jacks
No revocation or modification of this ruling appears in the Customs Bulletin issues read here (Nov 6, 2024 through Nov 18, 2026), where CBP publishes most such actions. That is not confirmation that the ruling is still in effect. Confirm its status with CBP before relying on it (ruling on CBP CROSS).
Key passages, quoted from the ruling
- Thus, based on the totality of the circumstances, the country of origin of the low-profile steel floor jacks (model numbers JA-GJ-325T and JA-GJ-450T) will be China.
Ruling text
In your letter dated October 8, 2025, you requested a country of origin ruling. The subject low profile steel hydraulic floor jacks are used to lift heavy loads through short distances and are suitable for use during automotive service or general machine maintenance. The jacks will be imported under two model numbers: a 3-ton low profile garage jack (model number JA-GJ-325T) and a 4-ton low profile garage jack (model number JA-GJ-450T).
Both models are identical in function but will have different lifting capacities and maximum lifting heights. Both model numbers will also be produced using the same manufacturing scenario, with final assembly occurring in Thailand using components sourced from China and Thailand. The Chinese components include a lifting arm assembly, steel side plates, a cover plate, a handle, a handle bracket, a saddle, a pump core, a pump cover, front wheels, rear casters, and more.
The only Thai component is a casting that will serve as the base for the pump unit. The main components of the hydraulic jacks are identified as the lifting arm assembly, the frame assembly, and the hydraulic unit. According to your submission, the operational steps that occur in Thailand begin with inspecting, cleaning, and drying the components for the hydraulic unit.
Once the components are cleaned, they are assembled using operational steps described as combining a pump housing, a cylinder body, a piston rod, a top cap, springs, washers, and other hardware into a hydraulic unit. Separately, the Chinese lifting arm assembly is attached to the frame assembly, which is formed by welding the side plates and other smaller metal shapes (e.g., brackets, rods, etc.) together.
The final assembly process is described as assembling the hydraulic unit to the frame assembly, then incorporating the rear caster assembly, handle bracket, saddle, etc., and securing everything together using fasteners. The hydraulic jack is then tested, inspected, and packaged for export. When determining the country of origin for purposes of applying current trade remedies under Section 301 and additional duties, the substantial transformation analysis is applicable.
See, e.g., Headquarters Ruling Letter H301619, dated November 6, 2018. The test for determining whether a substantial transformation will occur is whether an article emerges from a process with a new name, character, or use different from that possessed by the article prior to processing. See Texas Instruments Inc. v. United States, 681 F.2d 778 (C.C.P.A. 1982). This determination is based on the totality of the evidence.
See National Hand Tool Corp. v. United States, 16 C.I.T. 308 (1992), aff’d, 989 F.2d 1201 (Fed. Cir. 1993). CBP has held that whether an assembly process is sufficiently complex to rise to the level of a substantial transformation is determined upon consideration of all the operations that occur within that country, including any subassembly processes that take place in that country.
The text above is an excerpt. The official ruling, with its letterhead, signature and any attachments, is on CBP CROSS (N354791).