The country of origin of a compressor
No revocation or modification of this ruling appears in the Customs Bulletin issues read here (Nov 6, 2024 through Nov 18, 2026), where CBP publishes most such actions. That is not confirmation that the ruling is still in effect. Confirm its status with CBP before relying on it (ruling on CBP CROSS).
Ruling text
In your letter dated October 31, 2025, on behalf of your client, Universal Air Conditioner, LLC., you requested a country of origin ruling on a compressor to apply current trade remedies and for marking purposes. The product at issue is a compressor, SKU 68510505. The compressor is designed to be installed in a motor vehicle and connected to the belt system of the engine.
Once powered, the pistons of the compressor’s swashplate subassembly transfer rotational power within the planetary disc subassembly, which moves back and forth. The resulting motion pressurizes and displaces gas used in the air conditioning system. With respect to origin, the final assembly of the compressor occurs in Taiwan using components primarily from Taiwan and China. Prior to the final assembly, a cylinder block, rear and front covers, a rear cover plate and certain subassemblies are produced in Taiwan.
To produce the cylinder block, rear and front covers, and the rear cover plate, raw metal from Taiwan is melted in a furnace and subsequently pressed into a mold. Afterwards, the mold is deburred and shot blasted. Next, the covers, rear cover plate and cylinder block are machined. During the machining, the threaded holes and mounting grooves are formed using boring and facing operations. The production of the swashplate subassembly begins by sourcing a swashplate casting from China.
In Taiwan, the surfaces of the plate and shaft are turned, and holes are incorporated into the plate. The inclined surfaces are milled, and the working surfaces are ground. Afterwards, the swashplate is heat treated and anodized. To form the swashplate seat, raw material from China is forged, heat treated, and machined roughly and precisely to create the oil channels and mounting holes. The seat is then quenched and tempered. To form the main shaft and shaft arm, raw material is sourced from China and forged.
Afterwards, the forgings are quenched and tempered, followed by the quenching and tempering of the outer diameter and ends. The ends are drilled, machined, hardened and coated. To form the pulley, the outer surfaces of a forging blank from China are turned. The belt grooves are machined, a central hole is drilled, and all edges are chamfered. The burrs on the edges are removed. The pulley is then hardened and coated.
To form the coil, copper wire from China is connected to electrical terminals using a soldering process. Subsequently, the coil is inserted into a housing and encapsulated with epoxy. During the final assembly, a shim is inserted into a swashplate seat and swashplate and tightened using a machine. Then, a return spring is installed into the bottom of a main shaft arm. Afterwards, a connecting block and two shaft pins are inserted and pressed in place.
Next, a pin, a retaining ring and sleeve are manually inserted and pressed together. The process continues by threading a valve gasket and pressing it into a check valve, which is then screwed onto a rear cover. Bearings are then pressed in position, and a seat ring and washers are inserted into the cylinder block.
The text above is an excerpt. The official ruling, with its letterhead, signature and any attachments, is on CBP CROSS (N355567).