The country of origin of a fuel pump
No revocation or modification of this ruling appears in the Customs Bulletin issues read here (Nov 6, 2024 through Nov 18, 2026), where CBP publishes most such actions. That is not confirmation that the ruling is still in effect. Confirm its status with CBP before relying on it (ruling on CBP CROSS).
Ruling text
In your letter dated November 24, 2025, you requested a country of origin ruling on behalf of ACCAUTO (Thailand) Co., Ltd. Descriptive information regarding the assembly process was provided with your submission. The product at issue is referred to as a fuel pump. The fuel pump is an assembly that incorporates an electrically powered pump to continuously supply fuel from the tank to the fuel system. The assembly primarily consists of a pump core and various subassemblies.
The fuel pump is used in all-terrain vehicles, trucks, utility vehicles, and vehicles for passenger and commercial use. The final assembly of the fuel pump occurs in Thailand using subassemblies and components sourced from Thailand and China. Prior to the final assembly, the assembly of the pump core begins by press-fitting a shaft from China into a rotor core from China. Afterwards, insulation is installed, the rotor is press-fit into a commutator from China, and wire is wound onto the rotor.
Next, processes such as welding, injection molding, turning and deburring are completed which are followed by the assembly of an inductive core and coil. Subsequently, a brush from China is riveted to the coils and a stator from Thailand is magnetized. A pump casing is then assembled, a bearing is inserted into a bore of the inlet plate, which is followed by the installation of an end cap, a stator and a rotor.
Finally, an impeller from Thailand is press-fit onto the shaft of the rotor, a cover pad from China is pressed into the hole of an outlet plate and the resulting assembly is then pressed into one end of the pump shell. Both ends of the pump casing are crimped to seal the subassembly. The plastic flange subassembly is produced by securing a valve into the exhaust port of a plastic flange from Thailand using a snapping process.
To produce the housing subassembly, a diaphragm pad from China is installed and sealed into a reservoir from Thailand. The production of the fuel level sensor subassembly begins by soldering copper wires of the wiring harnesses from Thailand to the conductor area of the resistor, which is then installed into the resistor bracket from Thailand.
A shaft is then pressed into the center hole of the float arm bracket, an elastic contact is pressed into one end of the same bracket, and the float arm bracket is then aligned with the resistor bracket. Subsequently, a float is riveted to the float arm bracket, a cover is installed, and the float arm assembly is inserted into the open end of a bracket.
During the final assembly, the aforementioned subassemblies and other components such as waved pipes from Thailand, a filter from Thailand, a pressure regulator from China and a strainer from China are assembled to each other using processes such as press-fitting, inserting and soldering. These processes also include welding a plastic flange and a wiring harness in place and pressing rods into their respective holes. Lastly, a fuel level sensor subassembly and a dust cover are installed.
Throughout the various processes, the fuel pump undergoes various inspections and testing.
The text above is an excerpt. The official ruling, with its letterhead, signature and any attachments, is on CBP CROSS (N356398).