The tariff classification of bearings from Mexico
No revocation or modification of this ruling appears in the Customs Bulletin issues read here (Nov 6, 2024 through Nov 18, 2026), where CBP publishes most such actions. That is not confirmation that the ruling is still in effect. Confirm its status with CBP before relying on it (ruling on CBP CROSS).
Key passages, quoted from the ruling
- The general rate of duty will be 4.5 percent ad valorem.
Ruling text
In your letter dated December 2, 2025, you requested a tariff classification ruling on behalf of your client, Roller Bearings Company of America, Inc. Descriptive information was provided with your submission. The items at issue are referred to as the MS14 spherical plain bearings, part numbers 03-825-03, 03-824-06, 03-826-08 and 03-823-14. The bearings consist of an inner race shaped as a ball, a chamfered outer race and a polytetrafluoroethylene liner that is bonded to the inside diameter of the race.
The bearings, which are constructed from steel material, facilitate the pivoting movement of the rotating member and permit load transfer. The bearings are used in aircraft components such as actuators, engines, struts and subsystems such as flight control and landing gear subassemblies. In your submission, you suggest classifying the bearings within subheading 8807.30, Harmonized Tariff Schedule of the United States (HTSUS), which provides for parts of aircrafts.
You support your analysis by stating that the bearings are not integral parts of engines or motors, and cite Note 2(e) of Section XVII, excluding “Machines or apparatus of headings 8401 to 8479, or parts thereof, other than the radiators for the articles of this section; articles of heading 8481 or 8482 or, provided they constitute integral parts of engines or motors, articles of heading 8483” from this Section. We disagree.
Classification under the HTSUS is made in accordance with the General Rules of Interpretation (GRIs). GRI 1 provides that the classification of goods shall be determined according to the terms of the headings of the tariff schedule and any relative section or chapter notes.
Additional U.S. Rule of Interpretation 1(c) states that, in the absence of special language or context which otherwise requires, “a provision for parts of an article covers products solely or principally used as a part of such articles but a provision for ‘parts’ or ‘parts and accessories’ shall not prevail over a specific provision for such part or accessory.” The bearings at issue are not aircraft parts, but rather components of different systems within the aircraft, such as flight control systems, landing gear assemblies, and actuation systems.
As a result, they are subparts of particular parts. In this regard, we are guided by Mitsubishi Electronics America, Inc. v. United States, 19 C.I.T. 378 (1995), wherein the Court of International Trade discussed whether a clutch is classifiable as a part of an automobile. The court stated “that if the subject merchandise is not a clutch, but rather a part of a starter motor, then it cannot be classified as part of an automobile, even though it is used solely in automobiles.
This is because a subpart of a particular part of an article is more specifically provided for as a part of the part than as a part of the whole.” Similarly, the bearings in this case are subparts of systems and parts used in aircrafts. Since plain shaft bearings are specifically provided for within heading 8483, classification of the products within subheading 8807.30, HTSUS, is precluded.
The text above is an excerpt. The official ruling, with its letterhead, signature and any attachments, is on CBP CROSS (N356647).