The classification and country of origin of tire and rim assemblies
No revocation or modification of this ruling appears in the Customs Bulletin issues read here (Nov 6, 2024 through Nov 18, 2026), where CBP publishes most such actions. That is not confirmation that the ruling is still in effect. Confirm its status with CBP before relying on it (ruling on CBP CROSS).
Key passages, quoted from the ruling
- As a result, it is the opinion of this office, that the country of origin of the tire and rim assembly will be China.
Ruling text
In your letter dated December 11, 2025, you requested a classification and country of origin ruling on rubber tires mounted on aluminum rims. The three articles under consideration are 23*10R14 rubber tire mounted on 14*17 ET-20 aluminum rim, 225/50R14 rubber tire mounted on 14*7 ET-4 aluminum rim, and 23*10R14 rubber tire mounted on 14*7 ET-4 aluminum rim, which are used on golf carts. You state that each tire and rim assembly is at least 57 cm in diameter but not more than 63 cm.
According to the information provided, the aluminum rims, center dust caps, and valve stems are produced in China and sent to Vietnam for further assembly of with the Vietnam sourced rubber tires. The wheel assembly process in Vietnam begins with installing the valve onto the rim and securing it on the turntable. The tire is then mounted onto the rim according to directional markings and specialized equipment is used to press the upper and lower beads of the tire into the rim groove.
Once mounted, the tire is inflated to the standard pressure inside a safety cage, and the valve cap and hub cover are installed.
The applicable subheading for the tire and rim assemblies will be 8708.70.4546, Harmonized Tariff Schedule of the United States (HTSUS), which provides for “Parts and accessories to the motor vehicles of headings 8701 to 8705: Road wheels and parts and accessories thereof: For other vehicles: Other: Of aluminum: Wheels having a diameter of at least 57 cm but not more than 63 cm.” The general rate of duty will be 2.5 percent, ad valorem. The duties cited above are current as of this ruling’s issuance.
Duty rates are provided for your convenience and are subject to change. The text of the most recent HTSUS and the accompanying duty rates are provided at https://hts.usitc.gov/. This ruling does not address the applicability of any additional duties, taxes, fees, exactions and/or other charges, which may apply to the goods discussed herein. This includes, but is not limited to, tariffs and other duties as provided for in Subchapter III to Chapter 99, HTSUS.
Thus, for example, in addition to the classification stated above, the merchandise covered by this ruling may also need to be reported with either the Chapter 99 provision under which an additional tariff applies or one of the Chapter 99 provisions covering exceptions to such tariffs.
For further information to assist with the importation process, please refer to the frequently updated Cargo Systems Messaging Service (CSMS) messages at https://www.cbp.gov/trade/automated/cargo-systems-messaging-service and Frequently Asked Questions on the Trade Remedy/IEEPA page at https://www.cbp.gov/trade/programs-administration/trade-remedies/IEEPA-FAQ. When determining the country of origin, the substantial transformation analysis is applicable.
See, e.g., Headquarters Ruling Letter (“HQ”) H301619, dated November 6, 2018. The test for determining whether a substantial transformation will occur is whether an article emerges from a process with a new name, character, or use different from that possessed by the article prior to processing. See Texas Instruments Inc. v. United States, 681 F.2d 778 (C.C.P.A. 1982).
The text above is an excerpt. The official ruling, with its letterhead, signature and any attachments, is on CBP CROSS (N356961).