The country of origin of pliers
No revocation or modification of this ruling appears in the Customs Bulletin issues read here (Nov 6, 2024 through Nov 18, 2026), where CBP publishes most such actions. That is not confirmation that the ruling is still in effect. Confirm its status with CBP before relying on it (ruling on CBP CROSS).
Ruling text
In your letter dated December 12, 2025, you requested a country of origin ruling. Pictures of the items in different stages of manufacture were included with your submission, along with a narrative of the manufacturing process. The items under consideration are five types of pliers, identified as 10" groove joint pliers, 6" diagonal cutting pliers, 8" needle nose pliers, two pairs of 16" long reach pliers, and a four-piece set of tongue and groove joint pliers.
You have stated that the manufacturing process for the pliers is identical. The manufacturing process begins in Vietnam, where circular carbon steel is cut to length and then forged into the shape and form of the two halves of the pliers (i.e., the pieces incorporating the handles and jaws). These articles are sent to China where the center pivot hole is drilled into each, followed by additional shaping and assembly.
The piers are subsequently heat treated, polished, laser-engraved, and injection molded grips are applied to the handles. Finally, the finished pliers are packaged for shipment to the United States. When determining the country of origin for purposes of applying current trade remedies under Section 301 and additional duties, the substantial transformation analysis is applicable. See, e.g., Headquarters Ruling Letter H301619, dated November 6, 2018.
The test for determining whether a substantial transformation will occur is whether an article emerges from a process with a new name, character, or use different from that possessed by the article prior to processing. See Texas Instruments Inc. v. United States, 681 F.2d 778 (C.C.P.A. 1982). This determination is based on the totality of the evidence. See National Hand Tool Corp. v. United States, 16 C.I.T. 308 (1992), aff’d, 989 F.2d 1201 (Fed. Cir. 1993).
Additionally, Section 304 of the Tariff Act of 1930, as amended (19 U.S.C. 1304), provides that unless excepted, every article of foreign origin imported into the United States shall be marked in a conspicuous place as legibly, indelibly, and permanently as the nature of the article (or its container) will permit, in such a manner as to indicate to the ultimate purchaser in the United States, the English name of the country of origin of the article.
Congressional intent in enacting 19 U.S.C. 1304 was “that the ultimate purchaser should be able to know by an inspection of the marking on the imported goods the country of which the goods is the product. The evident purpose is to mark the goods so that at the time of purchase the ultimate purchaser may, by knowing where the goods were produced, be able to buy or refuse to buy them, if such marking should influence his will.” See United States v. Friedlander & Co., 27 C.C.P.A. 297, 302 (1940).
Part 134 of the U.S. Customs and Border Protection (“CBP”) Regulations (19 CFR 134) implements the country of origin marking requirements and exceptions of 19 U.S.C. 1304. Section 134.1(b), CBP Regulations (19 CFR 134.1(b)), defines “country of origin” as the country of manufacture, production, or growth of any article of foreign origin entering the United States.
The text above is an excerpt. The official ruling, with its letterhead, signature and any attachments, is on CBP CROSS (N356964).