The country of origin of an oxygen sensor
No revocation or modification of this ruling appears in the Customs Bulletin issues read here (Nov 6, 2024 through Nov 18, 2026), where CBP publishes most such actions. That is not confirmation that the ruling is still in effect. Confirm its status with CBP before relying on it (ruling on CBP CROSS).
Key passages, quoted from the ruling
- Accordingly, the country of origin of the oxygen sensor will be Thailand, which is where the functional subassemblies are created and the overall sensor is manufactured.
Ruling text
In your letter dated December 15, 2025, on behalf of your client, Accauto (Thailand) Co., Ltd, you requested a country of origin ruling on an oxygen sensor. Descriptive literature was provided for our review. The item under consideration is described as an oxygen sensor, which is designed for modern engines to monitor the oxygen concentration in engine exhaust and convert it into an electrical signal.
The signal is fed back to the electronic control unit (ECU) to adjust the air-fuel ratio, ensuring vehicle emissions meet environmental standards, and optimal engine and emissions system performance. The oxygen sensor is ultimately used in passenger vehicles, medium and heavy-duty trucks, and commercial vehicles, as well as all-terrain vehicles and utility task vehicles. The construction of the oxygen sensor includes parts from Thailand, China, and Japan.
The wire harness includes a Chinese or Thai plug, Chinese waterproof plug, leather hose, terminal block, wire connector, rubber wire sheath, shell, back cover, and Japanese wires. The probe assembly includes a Chinese inner protection tube, outer protection tube, house seal, ceramic base A, ceramic base B, dust cover, sealed powder, and chip. The house could be procured in China or Thailand. Finally, the Chip is manufactured in Thailand using parts from Japan and Thailand.
The Japanese components include the binder, plasticizer, protective layer slurry, catalytic electrode platinum paste, lead platinum paste of heater, pin platinum paste, heating platinum paste of heater, zirconia powder, and alumina powder. Finally, the Thai components are the xylene solvent and alcohol solvent. The oxygen sensor is manufactured utilizing four main modules that are all produced in Thailand.
The manufacturing process starts with the probe assembly, which is composed of six (6) key components: the ceramic sensitive element, hexagonal base, protective tube, ceramic seat A, ceramic seat B, and sealing ring. The process begins with pressing the protective tube onto the base to create the hexagonal base body, followed by inserting the ceramic element through the seats and sealing ring to form the core assembly.
This core is then placed into the hexagonal base and secured through riveting and sealing, completing the probe assembly. The finished probe undergoes electrical, dimensional, and air tightness tests on a fully automated assembly line, and only units that pass all inspections are accepted as qualified products. Next, is the chip core manufacturing process, which is organized into six (6) main stages encompassing a total of seventeen (17) steps.
It begins with raw material preparation, where ceramic powder is dried, batched with binders and solvents, and milled into a uniform slurry. The second stage focuses on film formation through tape casting, cutting, and drying to create stable ceramic sheets. In the third stage, the films are mounted, punched, printed with circuit patterns, and laminated into multilayer assemblies. Compaction and shaping follow, with vacuum sealing, warm isostatic pressing, and hot cutting to form consolidated cores.
The text above is an excerpt. The official ruling, with its letterhead, signature and any attachments, is on CBP CROSS (N357041).