The country of origin of linesman pliers
No revocation or modification of this ruling appears in the Customs Bulletin issues read here (Nov 6, 2024 through Nov 18, 2026), where CBP publishes most such actions. That is not confirmation that the ruling is still in effect. Confirm its status with CBP before relying on it (ruling on CBP CROSS).
Ruling text
In your letter dated December 17, 2025, you requested a country of origin ruling on linesman pliers. Pictures of the tool in different stages of manufacture were included with your submission, along with a narrative of the manufacturing processes. Linesman pliers are a type of pliers used by linemen, electrical contractors, and other tradesmen primarily for gripping, twisting, bending, and cutting wire, cable, and small metalwork components.
They are made of two pieces of steel, with each piece providing half of the handle and half of the working end. They have a beveled cutting edge near the joint of the working end’s jaw and teeth for gripping at the end of the nose. You have stated that the linesman pliers will be imported in different lengths. However, the manufacturing processes will be the same.
The manufacturing process for the linesman pliers involves drop-forging raw steel rods in Thailand into the shape and form of the two halves of the pliers (i.e., the pieces incorporating the handles and jaws). They are further trimmed and punched before being sent to China, where they are drilled with holes for assembly and teeth are milled into the jaws. Subsequently, the two halves are assembled by a rivet machine and then heat treated and polished.
The handles are coated with either single dip or double dip plastic. Finally, the pliers are laser marked with a logo and packaged for retail sale. When determining the country of origin for purposes of applying current trade remedies under Section 301 and additional duties, the substantial transformation analysis is applicable. See, e.g., Headquarters Ruling Letter H301619, dated November 6, 2018.
The test for determining whether a substantial transformation will occur is whether an article emerges from a process with a new name, character, or use different from that possessed by the article prior to processing. See Texas Instruments Inc. v. United States, 681 F.2d 778 (C.C.P.A. 1982). This determination is based on the totality of the evidence. See National Hand Tool Corp. v. United States, 16 C.I.T. 308 (1992), aff’d, 989 F.2d 1201 (Fed. Cir. 1993).
Additionally, Section 304 of the Tariff Act of 1930, as amended (19 U.S.C. 1304), provides that unless excepted, every article of foreign origin imported into the United States shall be marked in a conspicuous place as legibly, indelibly, and permanently as the nature of the article (or its container) will permit, in such a manner as to indicate to the ultimate purchaser in the United States, the English name of the country of origin of the article.
Congressional intent in enacting 19 U.S.C. 1304 was “that the ultimate purchaser should be able to know by an inspection of the marking on the imported goods the country of which the goods is the product. The evident purpose is to mark the goods so that at the time of purchase the ultimate purchaser may, by knowing where the goods were produced, be able to buy or refuse to buy them, if such marking should influence his will.” See United States v. Friedlander & Co., 27 C.C.P.A. 297, 302 (1940). Part 134 of the U.S.
The text above is an excerpt. The official ruling, with its letterhead, signature and any attachments, is on CBP CROSS (N357111).