The country of origin of a mass air flow sensor
No revocation or modification of this ruling appears in the Customs Bulletin issues read here (Nov 6, 2024 through Nov 18, 2026), where CBP publishes most such actions. That is not confirmation that the ruling is still in effect. Confirm its status with CBP before relying on it (ruling on CBP CROSS).
Ruling text
In your letter dated December 18, 2025, on behalf of your client, CrossCon Industries LLC, you requested a country of origin ruling on a mass air flow sensor. Descriptive literature was provided for our review. The item under consideration is described as a mass air flow (MAF) sensor (item no. DK-AF272S-P), which is a device used in the automotive industry to measure the amount of air entering the engine.
The information obtained by the sensor is used by the engine control unit (ECU) to calculate and deliver the appropriate amount of fuel for efficient combustion. The MAF sensor helps ensure the correct air-fuel ratio, which is essential for optimal engine performance, fuel efficiency, and emissions control. The MAF sensor achieves the appropriate air fuel ratio by utilizing a platinum heated wire or a hot film element, also referred to as a Resistance Temperature Detector (RTD).
The RTD is heated by an electrical current from the printed circuit board assembly (PCBA). The heated RTD is exposed to the air flow through a channel in the MAF sensor’s plastic housing. As the air flows through the channel, the heating element’s temperature changes, causing either current or voltage changes within the MAF sensor. The MAF sensor’s microcontroller unit (MCU) monitors the changes in current or voltage and translates this information into an air quantity signal.
An MCU is essentially a small, specialized computer on a single integrated circuit (IC) chip. It is designed to control specific operations within an embedded system, such as an MAF sensor. An MCU is further made up of several smaller key components, four of which are the Central Processing Unit (CPU), the memory (both read-only memory (ROM) and random access memory (RAM)), the input/output peripherals, and a clock. The signal from the MCU is then sent to vehicle’s engine ECU.
The CPU, as with other computer chips, is the brain of the MCU. It is responsible for executing instructions from the vehicle’s ECU. The ROM stores the MAF Sensor’s firmware while the RAM stores critical temporary data for successful operation of the MAF Sensor. Input and output peripherals allow the MCU to interact with the external world, such as reading sensor data or controlling actuators. And finally, the clock provides the timing signals that control the MCU’s operation.
In your letter, you present two scenarios where the manufacturing process is the same but the raw materials are sourced from different locations.
In scenario one, the operational amplifier and audion are sourced from the Philippines, while the remaining items are all sourced from China including the printed circuit board, capacitors, resistors, diodes, voltage stabilizer module, MCU, raw plastic, aluminum sheet, insulation pad, O-ring, thermistors, RTD, nickel-plated brass sheet material, stainless-steel nickel-plated sheet material, copper band, packing material, glue, and bonding wires.
The text above is an excerpt. The official ruling, with its letterhead, signature and any attachments, is on CBP CROSS (N357186).