The country of origin of control arms
No revocation or modification of this ruling appears in the Customs Bulletin issues read here (Nov 6, 2024 through Nov 18, 2026), where CBP publishes most such actions. That is not confirmation that the ruling is still in effect. Confirm its status with CBP before relying on it (ruling on CBP CROSS).
Ruling text
In your letter dated December 23, 2025, you requested a country of origin ruling on control arms. The articles under consideration are control arms, Part Numbers 1CMCK623245R, 1CMCK623246L, 1CMRK623508L, 1CMRK623509R, 1CMRK620564R, and 1CMRK620565L. The control arms, also known as A- arms, are hinged suspension links between the chassis and the suspension upright or hub, that carry the wheel.
In simple terms, they govern a wheel’s vertical travel, allowing it to move up or down when driving over bumps, into potholes, or otherwise reacting to the irregularities of a road surface. They also help to keep the wheels aligned and maintain proper tire contact with the road. The control arms mainly consist of upper and lower steel plates, ball stud assembly, bushing assembly, and bushing bracket assembly. You state that the manufacturing of the control arms occurs in Vietnam.
According to the bill of materials (BOM) for each control arm, the upper and lower steel plates are made with galvanized steel sheets, which are locally sourced in Vietnam. The manufacturing includes material cutting, drilling and spherical shell drilling, stretch forming, hole flaring, trimming, electric welding, grinding. Then, the ball stud assembly, bushing assembly, and bushing bracket assembly, which contain components from China and Vietnam, are assembled into the steel plates.
The finished product is then packaged ready for import. When determining the country of origin for purposes of applying current trade remedies under Section 301 and additional duties, the substantial transformation analysis is applicable. See, e.g., Headquarters Ruling Letter H301619, dated November 6, 2018.
The test for determining whether a substantial transformation will occur is whether an article emerges from a process with a new name, character, or use different from that possessed by the article prior to processing. See Texas Instruments Inc. v. United States, 681 F.2d 778 (C.C.P.A. 1982). This determination is based on the totality of the evidence. See National Hand Tool Corp. v. United States, 16 C.I.T. 308 (1992), aff’d, 989 F.2d 1201 (Fed. Cir. 1993).
Additionally, Section 304 of the Tariff Act of 1930, as amended (19 U.S.C. 1304), provides that unless excepted, every article of foreign origin imported into the United States shall be marked in a conspicuous place as legibly, indelibly, and permanently as the nature of the article (or its container) will permit, in such a manner as to indicate to the ultimate purchaser in the United States, the English name of the country of origin of the article.
Congressional intent in enacting 19 U.S.C. 1304 was “that the ultimate purchaser should be able to know by an inspection of the marking on the imported goods the country of which the goods is the product. The evident purpose is to mark the goods so that at the time of purchase the ultimate purchaser may, by knowing where the goods were produced, be able to buy or refuse to buy them, if such marking should influence his will.” See United States v. Friedlander & Co., 27 C.C.P.A. 297, 302 (1940). Part 134 of the U.S.
The text above is an excerpt. The official ruling, with its letterhead, signature and any attachments, is on CBP CROSS (N357277).