The country of origin of pliers
No revocation or modification of this ruling appears in the Customs Bulletin issues read here (Nov 6, 2024 through Nov 18, 2026), where CBP publishes most such actions. That is not confirmation that the ruling is still in effect. Confirm its status with CBP before relying on it (ruling on CBP CROSS).
Ruling text
In your letter dated January 2, 2026, you requested a country of origin ruling on five pairs of pliers, which are identified as follows: bent nose pliers, end cutting pliers, flat nose pliers, needle nose pliers, and hose grip pliers. Pictures of the tools in different stages of manufacture were included with your submission, along with a narrative of the manufacturing process.
All five pliers have tapered jaws that are used for gripping, twisting, bending, cutting stripping and crimping wires and other small objects. They are made of two pieces of steel, with each piece providing half of the handles and half of the pair of jaws. When joined together, the joint provides a fulcrum that transfers and increases the force applied to the handles by the user to the jaws. The manufacturing process for the five pairs of pliers is substantially the same.
It starts with drop-forging raw steel rods in Thailand into the shape and form of the two halves of the pliers (i.e., the pieces incorporating the handles and jaws). They are further die-cut and deburred to remove sharp edges and to form the contours and profiles of each tool. The articles are then sent to China, where they are drilled with holes and are joined together using rivet pins. The jaws are machined with teeth and/or cutting edges.
The pliers are sandblasted, heat treated, polished, and soft plastic or rubber grips are applied to the handles. Finally, the pliers are adjusted for alignment, oiled and packaged for retail sale. When determining the country of origin for purposes of applying current trade remedies under Section 301 and additional duties, the substantial transformation analysis is applicable. See, e.g., Headquarters Ruling Letter H301619, dated November 6, 2018.
The test for determining whether a substantial transformation will occur is whether an article emerges from a process with a new name, character, or use different from that possessed by the article prior to processing. See Texas Instruments Inc. v. United States, 681 F.2d 778 (C.C.P.A. 1982). This determination is based on the totality of the evidence. See National Hand Tool Corp. v. United States, 16 C.I.T. 308 (1992), aff’d, 989 F.2d 1201 (Fed. Cir. 1993).
Additionally, Section 304 of the Tariff Act of 1930, as amended (19 U.S.C. 1304), provides that unless excepted, every article of foreign origin imported into the United States shall be marked in a conspicuous place as legibly, indelibly, and permanently as the nature of the article (or its container) will permit, in such a manner as to indicate to the ultimate purchaser in the United States, the English name of the country of origin of the article.
Congressional intent in enacting 19 U.S.C. 1304 was “that the ultimate purchaser should be able to know by an inspection of the marking on the imported goods the country of which the goods is the product. The evident purpose is to mark the goods so that at the time of purchase the ultimate purchaser may, by knowing where the goods were produced, be able to buy or refuse to buy them, if such marking should influence his will.” See United States v. Friedlander & Co., 27 C.C.P.A. 297, 302 (1940). Part 134 of the U.S.
The text above is an excerpt. The official ruling, with its letterhead, signature and any attachments, is on CBP CROSS (N357430).