The country of origin of a bit socket
No revocation or modification of this ruling appears in the Customs Bulletin issues read here (Nov 6, 2024 through Nov 18, 2026), where CBP publishes most such actions. That is not confirmation that the ruling is still in effect. Confirm its status with CBP before relying on it (ruling on CBP CROSS).
Ruling text
In your letter dated January 6, 2026, you requested a country of origin determination for the purposes of Section 301 and IEEPA duties, and for marking purposes under Section 304 of the Tariff Act of 1930, as amended (19 U.S.C. 1304). The item under consideration is identified as a bit socket. It is a tool comprised of a bit holder socket with a press-fit bit. One end of the bit socket has a permanently attached bit (e.g., Philips head, Torx, Hex, etc.) that is used to turn a screw head.
The other end has a drive that allows the bit socket to be attached to a screwdriver handle, ratchet handle, or power (electric or pneumatic) drill. The manufacturing process for the bit socket takes place in two countries, Thailand and China. The bit is wholly manufactured in Thailand from raw steel, where it cut to shape and size, and the tip of the bit is machined to the required profile (e.g., Philips head, Torx, Hex, etc.).
The socket holder is cold forged from steel in China, then further machined to add precision. The Thai bit is sent to China and permanently affixed to the socket holder using a hydraulic press. When determining the country of origin for purposes of applying current trade remedies under Section 301 and additional duties, the substantial transformation analysis is applicable. See, e.g., Headquarters Ruling Letter H301619, dated November 6, 2018.
The test for determining whether a substantial transformation will occur is whether an article emerges from a process with a new name, character, or use different from that possessed by the article prior to processing. See Texas Instruments Inc. v. United States, 681 F.2d 778 (C.C.P.A. 1982). This determination is based on the totality of the evidence. See National Hand Tool Corp. v. United States, 16 C.I.T. 308 (1992), aff’d, 989 F.2d 1201 (Fed. Cir. 1993).
Additionally, Section 304 of the Tariff Act of 1930, as amended (19 U.S.C. 1304), provides that unless excepted, every article of foreign origin imported into the United States shall be marked in a conspicuous place as legibly, indelibly, and permanently as the nature of the article (or its container) will permit, in such a manner as to indicate to the ultimate purchaser in the United States, the English name of the country of origin of the article.
Congressional intent in enacting 19 U.S.C. 1304 was “that the ultimate purchaser should be able to know by an inspection of the marking on the imported goods the country of which the goods is the product. The evident purpose is to mark the goods so that at the time of purchase the ultimate purchaser may, by knowing where the goods were produced, be able to buy or refuse to buy them, if such marking should influence his will.” See United States v. Friedlander & Co., 27 C.C.P.A. 297, 302 (1940).
Part 134 of the U.S. Customs and Border Protection (“CBP”) Regulations (19 CFR 134) implements the country of origin marking requirements and exceptions of 19 U.S.C. 1304. Section 134.1(b), CBP Regulations (19 CFR 134.1(b)), defines “country of origin” as the country of manufacture, production, or growth of any article of foreign origin entering the United States.
The text above is an excerpt. The official ruling, with its letterhead, signature and any attachments, is on CBP CROSS (N357530).