The country of origin of window regulators
No revocation or modification of this ruling appears in the Customs Bulletin issues read here (Nov 6, 2024 through Nov 18, 2026), where CBP publishes most such actions. That is not confirmation that the ruling is still in effect. Confirm its status with CBP before relying on it (ruling on CBP CROSS).
Key passages, quoted from the ruling
- As a result, it is the opinion of this office that a substantial transformation occurs in Vietnam and the country of origin of the window regulators, Part Numbers 4030LT, 4061LT, 4162KT, and 4771LT, will be Vietnam for marking purposes.
Ruling text
In your letter dated January 16, 2026, you requested a country of origin ruling on window regulators. The articles under consideration are window regulators, Part Numbers 4030LT, 4061LT, 4162KT, and 4771LT, which are used in passenger vehicles. You state that a window regulator is a critical component located in the vehicle door that controls the movement of the window glass. It transforms the rotational force generated by an electric motor into linear motion, allowing the window to be raised and lowered smoothly.
This mechanism ensures convenient and reliable operation of power windows in modern automobiles. The window adjustment system begins by receiving a signal from the power window switch, which is then transmitted to the power window motor, activating the window regulator. This mechanism subsequently transfers power to the regulator handle, allowing the window glass to move up or down following the passenger's control.
The key components of a window regulator are guide rail, cables and related components, and a window lift motor. Part Numbers 4030LT, 4061LT, 4162KT, and 4771LT are window regulators without a motor. The guide rails with its supports and brackets, steel cable assemblies, and motor mounting brackets are produced in Vietnam from locally sourced galvanized steel sheet plates. These sheets undergo cutting, stretch forming, hole flaring, trimming, and electric welding and riveting to create these components.
Other components, such as pulleys, sleeves, coils, and other minor parts are made in China and imported into Vietnam for final assembly.
Section 304 of the Tariff Act of 1930, as amended (19 U.S.C. 1304), provides that unless excepted, every article of foreign origin imported into the United States shall be marked in a conspicuous place as legibly, indelibly, and permanently as the nature of the article (or its container) will permit, in such a manner as to indicate to the ultimate purchaser in the United States, the English name of the country of origin of the article.
Congressional intent in enacting 19 U.S.C. 1304 was “that the ultimate purchaser should be able to know by an inspection of the marking on the imported goods the country of which the goods is the product. The evident purpose is to mark the goods so that at the time of purchase the ultimate purchaser may, by knowing where the goods were produced, be able to buy or refuse to buy them, if such marking should influence his will.” See United States v. Friedlaender & Co., 27 C.C.P.A. 297, 302 (1940).
Part 134 of the U.S. Customs and Border Protection (“CBP”) Regulations (19 CFR 134) implements the country of origin marking requirements and exceptions of 19 U.S.C. 1304. Section 134.1(b), CBP Regulations (19 CFR 134.1(b)), defines “country of origin” as the country of manufacture, production, or growth of any article of foreign origin entering the United States.
Further work or material added to an article in another country must effect a substantial transformation in order to render such other country the “country of origin” within the meaning of the marking laws and regulations.
The text above is an excerpt. The official ruling, with its letterhead, signature and any attachments, is on CBP CROSS (N357918).