The country of origin of OSFP transceiver modules
No revocation or modification of this ruling appears in the Customs Bulletin issues read here (Nov 6, 2024 through Nov 18, 2026), where CBP publishes most such actions. That is not confirmation that the ruling is still in effect. Confirm its status with CBP before relying on it (ruling on CBP CROSS).
Ruling text
In your letter dated February 3, 2026, you requested a country of origin ruling on behalf of your client Accelink Technologies, for Octal Small Form Factor Pluggable transceiver modules. The item concerned is referred to as the 800G Octal Small Form Factor Pluggable (OSFP) DR8 transceiver module. This is a transceiver that will be mounted on each end of a length of fiber optic cable. The subject merchandise is a hot-pluggable module that plugs into network devices, such as switches in data centers.
It is used to convert an electrical signal into an optical signal, and conversely an optical signal back into electrical signal. These transceivers are designed for use in 800 Gigabit Ethernet links on up to 500m of single mode fiber. They are used in networking and data communications sectors in order to receive, convert, and transmit different signals. The main components of the OSFP transceiver are the printed circuit board assembly (PCBA), the optical subassembly (OSA), and the transceiver housing.
OSA (China-Origin): The OSA includes both a transmit optical subassembly (TOSA) and a receive optical subassembly (ROSA). The TOSA and ROSA are referred to as a transmitter (Tx) and receiver (Rx). The Tx part of the OSA is responsible for converting the electrical signals into optical signals and transmitting these signals over an optical fiber strand in the fiber array (FA). It uses a laser diode to generate and focus a light beam into a Silicon Photonic (SiPho) integrated circuit.
The photonic integrated circuit splits the light signal into four light beams. An electrical signal from the main PCBA is used to modulate the four light beams which are then launched into the optical fibers of the FA via the isolator focus optics. The Tx part of the OSA is manufactured in China and attached to the Malaysia-origin PCBA in China.
The Rx part of the OSA is responsible for receiving the optical signals transmitted from the Tx and converting them back to electrical signals so that the communication equipment can understand them. The Rx part of the OSA consists of an Rx block, four photodiodes, two single-layer capacitors, and a transimpedance amplifier. The Rx part of the OSA each receives four light beams from optical fibers and sends them to four photodiodes.
It is the photodiodes that convert the light signals into electrical signals which are then amplified by the transimpedance amplifier on the PCBA. The Rx part of OSA is manufactured in China and attached to the Malaysia-origin PCBA in China. Main Board PCBA (Malaysia-origin) The Main Board PCBA contains approximately 560 electrical elements sourced from various countries of origin. The main electrical element on the PCBA is the digital signal processor (DSP) chip of U.S.-origin.
This is the highest value item on the BOM and a critical component of the PCBA. The Main Board PCBA is the foundation of the transceiver and imparts its essence. Without the Main Board PCBA, the Tx part of the OSA cannot generate optical signals and the Rx part of the OSA cannot convert optical signals into electrical signals The DSP provides for signal amplification, detection, regeneration, and reconditioning.
The text above is an excerpt. The official ruling, with its letterhead, signature and any attachments, is on CBP CROSS (N358465).