The country of origin and marking of gear pumps
No revocation or modification of this ruling appears in the Customs Bulletin issues read here (Nov 6, 2024 through Nov 18, 2026), where CBP publishes most such actions. That is not confirmation that the ruling is still in effect. Confirm its status with CBP before relying on it (ruling on CBP CROSS).
Ruling text
In your letter dated February 5, 2026, you requested a country of origin ruling on behalf of your client, Permco, Inc. You also inquire about a labeling option for the purpose of marking the gear pumps. A description of the final assembly processes was provided in the submission. The products at issue are the 2100 Series Hydraulic Gear Pumps, which will be imported in 13 different configurations. The rotary positive displacement pumps are used in industrial fluid power systems.
Each pump consists of a housing that sits between a shaft and covers. These housings enclose valves, a seal, gaskets, and gear units that consist of a gear on a shaft. The interlocking gear units are designed to repeatedly move fluid. The variations of the pumps are driven by customer needs and catalog options, which impact pump size, port or drain configurations and mounting styles.
The part numbers of the pumps are P2100A231IDZK20-87, P2100A231IDZK20-87 (CHE), M2100A886SPLADDE20-32PS (CHA), P2100A231IX12ZK25-87, P2100A290IDZK20-14, P2100A290IDZA20-14, M2100A886SPLADDE15-32PS (CHA), P2100A231IX12ZK25-87 (CHE), P2100W290SPLIDZA20-14 (SNW), P2100W290SPLIDZA17-14 (SNW), P2100W290SPLIDZK20-14 (SNW), P2100W290SPLIDZK17-14 (SNW) and P2100A290IDZK17-14.
It is noted that a country of origin ruling for this product, in which the final assembly occurs in the United Kingdom, was previously issued in New York Ruling N354559, dated October 22, 2025. Here, the final assembly of the gear pump will occur in China using components sourced from the United States and other countries, such as China, India, etc.
Prior to the final assembly, steel slugs are ground, saw cut, shaped, shaved, milled, heat treated and lapped to achieve the exact tolerances of an idler and drive gear in the United States. Once the finished gear units are exported to China, the faces of the gears are stoned and subject to a deburring process. In China, a shaft end cover, a port end cover and a gear housing, which are either from China, United States or India, undergo additional processing.
The shaft end cover undergoes a deburring process, sealant is applied, and a ring seal, check valves, and bearings from China or the United States are inserted into the designated bores. The port end cover undergoes a deburring process, and afterwards a ring seal and bearings from China or the United States are inserted into the cover. The housing, referred to as a gear housing, which is either from China or India, is also deburred.
The final assembly begins by inserting dowel pins and a thrust end plate into a shaft end cover. Next, the shaft ends of the gear units are inserted into the bores of the shaft end cover. A gasket seal, which is sourced from Vietnam, is installed into a gear housing. Afterwards, the gear housing is placed over the shaft end cover, which is followed by the application of grease. Subsequently, a port end cover is placed over the gear housing and is manually aligned, pressed and hammered in position.
The components are then affixed in position using bolts. Lastly, the pump is labeled, inspected and finished by adding plastic caps.
The text above is an excerpt. The official ruling, with its letterhead, signature and any attachments, is on CBP CROSS (N358593).