The country of origin of a pipe assembly.
No revocation or modification of this ruling appears in the Customs Bulletin issues read here (Nov 6, 2024 through Nov 18, 2026), where CBP publishes most such actions. That is not confirmation that the ruling is still in effect. Confirm its status with CBP before relying on it (ruling on CBP CROSS).
Key passages, quoted from the ruling
- The pipe assembly is classified under subheading 8708.99, Harmonized Tariff Schedule of the United States (HTSUS).
Ruling text
In your letter dated February 9, 2026, you requested a country of origin ruling on a pipe assembly for marking purposes and for purposes of applying additional duties. The article under consideration is a pipe assembly heater (Part 21022-9BT0A), which is used in passenger vehicles. You describe it as a circulation channel of the coolant from the radiator to the engine. It is situated between the radiator and the engine.
The pipe assembly heater consists of four pipes (pipe 11, 12, 13, and 14), a flange, and two brackets. According to the flowcharts you supplied, the steel pipes, flange, and brackets are made in South Korea. You state that pipe bending occurs in South Korea.
The components are then sent to Mexico where the following processes occur: spot welding of pipe 11 with pipe 14, spot welding of the welded product with one bracket, spot welding of pipe 13 with another bracket, caulking pipe 12 with the flange, expanding and brazing the product, adjusting the shape, leak testing, plating, and inspection.
Section 304 of the Tariff Act of 1930, as amended (19 U.S.C. 1304), provides that unless excepted, every article of foreign origin imported into the United States shall be marked in a conspicuous place as legibly, indelibly, and permanently as the nature of the article (or its container) will permit, in such a manner as to indicate to the ultimate purchaser in the United States, the English name of the country of origin of the article.
Congressional intent in enacting 19 U.S.C. 1304 was “that the ultimate purchaser should be able to know by an inspection of the marking on the imported goods the country of which the goods is the product. The evident purpose is to mark the goods so that at the time of purchase the ultimate purchaser may, by knowing where the goods were produced, be able to buy or refuse to buy them, if such marking should influence his will.” See United States v. Friedlaender & Co., 27 C.C.P.A. 297, 302 (1940).
Section 134.1(b), CBP Regulations (19 CFR 134.1(b)), defines “country of origin” as the country of manufacture, production, or growth of any article of foreign origin entering the United States. Further work or material added to an article in another country must effect a substantial transformation in order to render such other country the “country of origin” within the meaning of the marking laws and regulations.
Pursuant to section 102.0, interim regulations, related to the marking rules, tariff-rate quotas, and other USMCA provisions, published in the Federal Register on July 6, 2021 (86 FR 35566), the rules set forth in §§ 102.1 through 102.18 and 102.20 determine the country of origin for marking purposes with respect to goods imported from Canada and Mexico.
Section 102.11 provides a required hierarchy for determining the country of origin of a good for marking purposes, with the exception of textile goods which are subject to the provisions of 19 C.F.R. § 102.21. See 19 C.F.R. § 102.11.
The text above is an excerpt. The official ruling, with its letterhead, signature and any attachments, is on CBP CROSS (N358639).