The country of origin of a brake caliper
No revocation or modification of this ruling appears in the Customs Bulletin issues read here (Nov 6, 2024 through Nov 18, 2026), where CBP publishes most such actions. That is not confirmation that the ruling is still in effect. Confirm its status with CBP before relying on it (ruling on CBP CROSS).
Key passages, quoted from the ruling
- Therefore, the country of origin of the brake caliper, model EX851005M, will be Malaysia.
Ruling text
In your letter dated February 20, 2026, you requested a country of origin ruling on a brake caliper, on behalf of your client, Yusin Machinery (Malaysia) Sdn Bhd. The article under consideration has been identified as a brake caliper, part number EX851005M. The brake caliper is a critical component incorporated into the disk brake system in a motor vehicle. The primary function of the subject merchandise is to apply pressure to the brake pads, which in turn creates friction against the brake rotor or disc.
The applied friction then slows the motor vehicle, creating a controlled stop. The brake caliper fits over the rotor similar to a clamp. The brake caliper under consideration consists of a caliper body, which is made in Malaysia, and a piston, seal ring, rubber sleeve, and bleeder from China, which are imported to Malaysia for further assembly with the caliper body.
To create the caliper body, raw aluminum from Malaysia is smelted to produce molten aluminum and then poured into casting molds, creating the initial caliper blank. This step is followed by the removal of excessive waste materials, further heat treatment, and sandblasting, which creates the finished brake caliper blank. The brake caliper blank is further processed by adding bore, mounting holes, annular and sleeve grooves, and the arc shape to the caliper cylinder body in Malaysia.
The caliper body is then assembled with the piston, seal ring, rubber sleeve, and bleeder. Finally, the product is tested for quality assurance and packaged for importation into the United States. When determining the country of origin, the substantial transformation analysis is applicable. See, e.g., Headquarters Ruling Letter (“HQ”) H301619, dated November 6, 2018.
The test for determining whether a substantial transformation will occur is whether an article emerges from a process with a new name, character, or use different from that possessed by the article prior to processing. See Texas Instruments Inc. v. United States, 681 F.2d 778 (C.C.P.A. 1982). This determination is based on the totality of the evidence. See National Hand Tool Corp. v. United States, 16 C.I.T. 308 (1992), aff’d, 989 F.2d 1201 (Fed. Cir. 1993).
CBP previously ruled on a similar scenario in New York Ruling N355045, dated November 17, 2025. In this ruling, we stated that the caliper body from Thailand was the largest component that clamped directly onto the brake rotor to stop it from spinning. This office also noted that the value of the caliper body was significantly higher than the value of other components imported from China and the final assembly of all components into the complete brake caliper also occurred in Thailand.
As a result, we ruled that the country of origin was Thailand. Here, too, the caliper body from Malaysia is the largest component that clamps directly onto the brake rotor to stop it from spinning, and the value of the caliper body amounts to 86 percent of the total cost. Thus, it is the opinion of this office that the caliper body imparts the character of the entire assembly. Furthermore, the final assembly of all components also occurs in Malaysia.
The text above is an excerpt. The official ruling, with its letterhead, signature and any attachments, is on CBP CROSS (N359040).