The country of origin of an ignition distributor for an automotive engine
No revocation or modification of this ruling appears in the Customs Bulletin issues read here (Nov 6, 2024 through Nov 18, 2026), where CBP publishes most such actions. That is not confirmation that the ruling is still in effect. Confirm its status with CBP before relying on it (ruling on CBP CROSS).
Ruling text
In your letter dated February 26, 2026, you requested a country of origin ruling on an Ignition Distributor for an automotive engine. A distributor in an ignition system acts as a specialized rotary switch, routing high-voltage electricity from the ignition coil to the correct spark plug in the proper firing order. Driven by the camshaft, the distributor ensures precise timing of the spark for combustion.
In your request, you state that the ignition distributor part number DST1830 is assembled in Malaysia, consisting of materials from Chinese, Malaysian or Taiwanese origin. A Bill of Materials (BOM) was submitted, along with the ignition distributor production process and other documents, illustrations, and a YouTube video showing the production work done in Malaysia.
The production steps shown in your video from Malaysia include: Machining of shaft Injection molding of plastic casing and i nstallation of spring washer screws Fitting the distributor cap into the module groove of the shaft and then placing the DST1830 Shaft, with the drive gear section, into the hole of fixture L10/F-ST-01 Fit the rotor into the groove of the shaft and positioning the 4 pins of the distributor cap into the steel plate Machine and press the steel plate into the distributor cap.
Placing M3.5X0.6 spring washer screws into the screw holes of the distributor cap Perform a final pass to secure both evenly. Ensure that the spring washers are flat after tightening. Installation of distributor, and rotor Applying of warranty sticker. Arrange all components on the shelf trolley. When determining the country of origin for purposes of applying current trade remedies under Section 301, and additional duties, the substantial transformation analysis is applicable.
See, e.g., Headquarters Ruling Letter H301619, dated November 6, 2018. The test for determining whether a substantial transformation will occur is whether an article emerges from a process with a new name, character, or use different from that possessed by the article prior to processing. See Texas Instruments Inc. v. United States, 681 F.2d 778 (C.C.P.A. 1982). This determination is based on the totality of the evidence.
See National Hand Tool Corp. v. United States, 16 C.I.T. 308 (1992), aff’d, 989 F.2d 1201 (Fed. Cir. 1993).
Additionally, Section 304 of the Tariff Act of 1930, as amended (19 U.S.C. 1304), provides that unless excepted, every article of foreign origin imported into the United States shall be marked in a conspicuous place as legibly, indelibly, and permanently as the nature of the article (or its container) will permit, in such a manner as to indicate to the ultimate purchaser in the United States, the English name of the country of origin of the article.
Congressional intent in enacting 19 U.S.C. 1304 was “that the ultimate purchaser should be able to know by an inspection of the marking on the imported goods the country of which the goods is the product.
The text above is an excerpt. The official ruling, with its letterhead, signature and any attachments, is on CBP CROSS (N359247).