The tariff classification of a mandrel from Switzerland
No revocation or modification of this ruling appears in the Customs Bulletin issues read here (Nov 6, 2024 through Nov 18, 2026), where CBP publishes most such actions. That is not confirmation that the ruling is still in effect. Confirm its status with CBP before relying on it (ruling on CBP CROSS).
Key passages, quoted from the ruling
- The applicable subheading for the mandrel will be 7326.90.8688, HTSUS, which provides for “Other articles of iron or steel: Other: Other: Other: Other: Other.” The general rate of duty will be 2.9 percent ad valorem.
Ruling text
In your letter dated March 10, 2026, you requested a tariff classification ruling. Descriptions, technical information, and photographs were submitted with your request. The item under consideration is described as a mandrel, Model # 300180340. The mandrel is a steel article designed to act as a sealing plug in bore openings. Prior to installation it is akin to a drill bit. There is a bell- shaped head that ranges in diameter from 4 to 18 millimeters.
At the top of the head, there is a narrow groove that widens out to a smooth shaft and becomes threaded at its far end. The head is designed to serve as the plug when the mandrel is installed, and the shaft enables the plug to be installed through a hydraulic, or pneumatic hand tool, comparable to a drill. In the process of installation, the shaft is attached to the hand tool, while the head is pushed through a bore opening.
Once the head reaches its required point of installation it breaks off the shaft along the narrow groove leaving only the head installed as a plug while the shaft is discarded. Heading 7326, Harmonized Tariff Schedule of the United States (HTSUS), is a residual or basket provision which covers a wide range of iron or steel articles that are not more specifically provided for elsewhere in the HTSUS.
The Explanatory Notes (ENs) to heading 7326, HTSUS state that “This heading covers all iron or steel articles obtained by forging or punching, by cutting or stamping or by other processes such as folding, assembling, welding, turning, milling or perforating other than articles included in the preceding headings of this Chapter or covered by Note 1 to Section XV or included in Chapter 82 or 83 or more specifically covered elsewhere in the Nomenclature.” An article of iron or steel can be classified in heading 7326, HTSUS if it is determined that the item is not more specifically provided for in any other heading of the tariff.
The mandrel is not specifically covered elsewhere in the tariff. Accordingly, it is classifiable in heading 7326, HTSUS. The applicable subheading for the mandrel will be 7326.90.8688, HTSUS, which provides for “Other articles of iron or steel: Other: Other: Other: Other: Other.” The general rate of duty will be 2.9 percent ad valorem. The duties cited above are current as of this ruling’s issuance. Duty rates are provided for your convenience and are subject to change.
The text of the most recent HTSUS and the accompanying duty rates are provided at https://hts.usitc.gov/. This ruling does not address the applicability of any additional duties, taxes, fees, exactions and/or other charges, which may apply to the goods discussed herein. This includes, but is not limited to, tariffs and other duties as provided for in Subchapter III to Chapter 99, HTSUS.
Thus, for example, in addition to the classification stated above, the merchandise covered by this ruling may also need to be reported with either the Chapter 99 provision under which an additional tariff applies or one of the Chapter 99 provisions covering exceptions to such tariffs.
The text above is an excerpt. The official ruling, with its letterhead, signature and any attachments, is on CBP CROSS (N359616).