The tariff classification of a front subframe and control arms from Poland
No revocation or modification of this ruling appears in the Customs Bulletin issues read here (Nov 6, 2024 through Nov 18, 2026), where CBP publishes most such actions. That is not confirmation that the ruling is still in effect. Confirm its status with CBP before relying on it (ruling on CBP CROSS).
Ruling text
In your letter dated March 12, 2026, you requested a tariff classification ruling. The articles under consideration are a Tubular Front Subframe (Part Number MX5-XNA-SAN-KIX-001), an Adjustable Camber Control Arms (Part Number MX5-NAB-WAH-XPG-001), and an Adjustable Front Control Arms (Part Number JEP-ZXJ-WAH-PTG-001) used in passenger vehicles. The Tubular Front Subframe is an aftermarket good designed to replace the original stamped steel front subframe in a Mazda MX-5 NA (1989-1997).
The subframe serves as the primary load-bearing structure connecting lower and upper control arms, engine mounts, and steering components. Additional mounting points positioned 18 mm higher provide roll center correction for lowered vehicles, improving suspension geometry and reducing understeer. The triangulated chromoly tubular construction increases torsional stiffness while reducing overall weight compared to the OEM component.
The method of installation includes the subject merchandise being bolted directly to the factory chassis mounting points with included mounting hardware. The total weight of the carbon steel subframe is approximately 33 lbs. The Adjustable Camber Control Arms is an aftermarket set designed for installation in a Mazda MX-5 NA (1989-1997) and NB (1998-2005). The primary function of the product is to connect the wheel hub assembly to the chassis while allowing adjustment of the camber angle.
The product improves suspension geometry tuning capability and increases structural rigidity in comparison to OEM steel control arms. The Adjustable Camber Control Arms form a part of the suspension linkage system. The product pivots at the chassis mounting points using polyurethane bushings and connects to the hub assembly via a pivot mechanism. The adjustable geometry allows precise camber angle setting over a wide adjustment range.
Suspension response and handling stability is improved by the structural integrity of the 4130 chromoly tubular construction. The method of installation includes bolting the product to the factory suspension mounting points using supplied hardware and OEM pivot location. The material composition of the main structure is 4130 chromium-molybdenum steel tubing and sheet metal, the pivot housing is constructed of 7075-T6 aluminum, and the bushings are composed of polyurethane.
The total weight of the Adjustable Camber Control Arms is approximately 6 lbs. At the time of U.S. importation, the Adjustable Camber Control Arms will include two adjustable control arms, two pivots with nuts, two aluminum pivot housings, polyurethane bushings, steel washers, pivots, and steel sleeves. The Adjustable Front Control Arms-Off-Road Application is an aftermarket suspension control arm designed for off-road motor vehicle use in a Jeep ZJ, TJ, and XJ.
The primary function of the product is to connect the axle assembly to the vehicle chassis and allow adjustment of the pinion and caster angles after suspension lift modifications. The component provides a recentering of the axle within the wheel arch after suspension height changes.
The text above is an excerpt. The official ruling, with its letterhead, signature and any attachments, is on CBP CROSS (N359677).