The tariff classification of a clutch from Canada
No Headquarters ruling in this index revokes or modifies this ruling. That is not confirmation that it is still in effect: this index does not hold every Headquarters ruling. Confirm its current status with CBP before relying on it (ruling on CBP CROSS). Text last read from CBP on Nov 21, 2026.
Key passages, quoted from the ruling
- The applicable subheading for the clutch, Part Number 15568, will be 8708.93.6000, HTSUS, which provides for “Parts and accessories of the motor vehicles of Headings 8701 to 8705: Other parts and accessories: Clutches and parts thereof: For other vehicles: Clutches.” The general rate of duty will be 2.5 percent ad valorem.
Ruling text
In your letter dated March 24, 2026, you requested a tariff classification ruling. The article under consideration is a clutch, Part Number 15568, which is designed to be used in automatic transmissions of passenger vehicles. The clutch is primarily used to connect and disconnect power once actuated via the solenoid. A speed sensor assembly is also a component within the clutch. The 15568 clutch requires the use of fluid coupling and automatic control actuation controlled by a solenoid.
It is used in conjunction with other automatic transmission internal components to cause the gear speed setting of the automatic transmission to change for higher speeds or for lower speeds. These automatic transmissions have gears defined as Park, Reverse, and Drive. Within Drive, anywhere from four to six gear, or speed settings are in place within the automatic transmission to accommodate a speed range for highway, city, or off-road.
These speeds are set in part by the subject merchandise working in conjunction with the other automatic transmission components. The clutch contains an inner race and outer race that are both made from sintered powdered metal. The internal parts are steel. Internally, there are steel struts that only allow the inner race to rotate in one direction. The outer race is fixed to the inside of the transmission case, while the inner race is able to rotate in one direction.
The component that is keyed/splined to the inner race can rotate freely in the counter-clockwise direction, allowing the transmission to engage any gear but 1st or reverse. With no change to the clutch settings, other internal transmission components are engaged causing parts through the inside of the clutch to attempt clockwise rotation which is prevented by the clutch engagement. This results in the transmission engaging 1st gear.
A solenoid actuator via a rocker assembly can lock rotation in the counter-clockwise direction and allows the transmission to engage reverse gear. In both directions the “locking” is controlled by steel tabs (struts) that act similarly to a conventional ratchet. In one direction the ramps will click past the struts and in the other direction the struts catch the ramps.
The struts that prevent clockwise rotation are always engaged with the solenoid through a rocker to actuate the struts that lock/prevent counter-clockwise rotation. The solenoid is DC powered by the vehicle battery system.
In your submission, you state that the subject clutch component is not classified under subheading 8505.20.0000, Harmonized Tariff Schedule of the United States (HTSUS), which provides for “Electromagnets; permanent magnets and articles intended to become permanent magnets after magnetization; electromagnetic or permanent magnet chucks, clamps and similar holding devices; electromagnetic couplings, clutches and brakes; electromagnetic lifting heads; parts thereof: Electromagnetic couplings, clutches and brakes.” We agree.
While the clutch component does incorporate a solenoid, its function is limited to enabling the transmission to engage reverse gear.
The text above is an excerpt. The official ruling, with its letterhead, signature and any attachments, is on CBP CROSS (N359991).