The country of origin of a compressor
No revocation or modification of this ruling appears in the Customs Bulletin issues read here (Nov 6, 2024 through Nov 18, 2026), where CBP publishes most such actions. That is not confirmation that the ruling is still in effect. Confirm its status with CBP before relying on it (ruling on CBP CROSS).
Ruling text
In your letter dated March 31, 2026, on behalf of your client, Universal Air Conditioner, LLC., you requested a country of origin ruling on a compressor to apply current trade remedies and for marking purposes. It is noted that this office previously addressed the country of origin of a similar compressor used in an air conditioning system of a motor vehicle for the same requester. See New York Ruling Letter N355567, dated November 26, 2025, The product at issue is a compressor, model number CO 29162C.
The compressor is designed to be installed in a motor vehicle and connected to the belt system of the engine. Once powered, the swashplate turns to drive the slippers, converting the rotary motion of the main shaft into the reciprocating motion of the compressor’s pistons, which move back and forth. The resulting motion pressurizes and displaces gas used in the air conditioning system. With respect to origin, the final assembly of the compressor occurs in South Korea using components from South Korea and China.
Prior to the final assembly, the front and rear cylinder blocks, the front and rear housings, the swashplate, the pulley, the main shaft and arm, the coil and the clutch hub are produced in South Korea. To produce the housings and blocks, raw metal from South Korea is melted in a furnace and subsequently pressed into a mold. Afterwards, the resulting cast is deburred, shot blasted and machined. During the machining processes, the threaded holes and mounting grooves are formed using boring and facing operations.
The swashplate from South Korea is machined on the surface and inner and outer diameters. To form the main shaft and shaft arm, raw material is sourced from China and forged. Afterwards, the forgings are quenched and tempered. Afterwards, the ends are drilled, machined, hardened and coated. To form the pulley, the outer surfaces of a forging blank from China are turned. The belt grooves are machined, a central hole is drilled and all edges are chamfered. The burrs are removed, and the bearing seat is finished.
The pulley is then hardened and coated. To form the coil, copper wire from South Korea is cut, stripped and connected to electrical terminals using a crimping process. Subsequently, the coil is inserted into a steel housing and afterwards wound and magnetized. To form the clutch hub, a rubber molded component, an armature, and rivets from South Korea are assembled to each other. The subassembly is then inserted into a grinding machine to achieve a specific flatness and surface finish.
The final assembly begins by positioning and pressing a main shaft onto a swashplate. Afterwards, the resulting swashplate subassembly is clamped to five pistons and ten slippers from China. In sequence, bearings from China and the swashplate subassembly are pressed into a front cylinder block. Next, a rear cylinder block is installed, lubricant is applied, and a shaft seal and retainer are installed. The process continues by combining pins, washers, a plate from China, and a suction valve from China.
Afterwards, an oil plug from China is installed, and a seal is pressed onto the front cover.
The text above is an excerpt. The official ruling, with its letterhead, signature and any attachments, is on CBP CROSS (N360226).