The tariff classification of a well seal kit from Canada
No revocation or modification of this ruling appears in the Customs Bulletin issues read here (Nov 6, 2024 through Nov 18, 2026), where CBP publishes most such actions. That is not confirmation that the ruling is still in effect. Confirm its status with CBP before relying on it (ruling on CBP CROSS).
Key passages, quoted from the ruling
- The applicable subheading for the well seal kit will be 4016.93.5050, HTSUS, which provides for other articles of vulcanized rubber other than hard rubber: other: gaskets, washers and other seals: other: other.
- The general rate of duty will be 2.5 percent ad valorem.
Ruling text
In your letter dated April 6, 2026, you requested a tariff classification ruling on behalf of your client, Boshart Industries. The product under consideration is Part # WSP6012, Single Hole Plastic Well Seal-6”x1-¼” (Well Seal). The well seal is a kit consisting of a top and bottom plate composed of acrylonitrile-butadiene-styrene (ABS) plastic, a gland composed of styrene butadiene (SBR) rubber, grommets, bolts, and nuts. The rubber gland is sandwiched between the top and bottom plates.
The three pieces contain holes for fasteners. The bolts and nuts are inserted through the holes and when tightened the plastic plates compress the rubber gland expanding it onto the sides of the well to create the seal. The plastic plates and rubber gland also include holes to accommodate grommets that allow pipe and wiring to pass through the seal into the well.
In your submission, you proposed that this well seal kit should be classified under subheading 3926.90.4590, Harmonized Tariff Schedule of the United States (HTSUS), which provides for plastic gaskets, washers, and other seals. While we agree that this product would qualify as a General Rule of Interpretation 3(b) set, we disagree that the plastic plates would impart the essential character.
Rather, we hold the opinion that it is the rubber gland, which is compressed to form the seal within the well, that would provide the classification to this kit. The applicable subheading for the well seal kit will be 4016.93.5050, HTSUS, which provides for other articles of vulcanized rubber other than hard rubber: other: gaskets, washers and other seals: other: other. The general rate of duty will be 2.5 percent ad valorem. The duties cited above are current as of this ruling’s issuance.
Duty rates are provided for your convenience and are subject to change. The text of the most recent HTSUS and the accompanying duty rates are provided at https://hts.usitc.gov/. This ruling does not address the applicability of any additional duties, taxes, fees, exactions and/or other charges, which may apply to the goods discussed herein. This includes, but is not limited to, tariffs and other duties as provided for in Subchapter III to Chapter 99, HTSUS.
Thus, for example, in addition to the classification stated above, the merchandise covered by this ruling may also need to be reported with either the Chapter 99 provision under which an additional tariff applies or one of the Chapter 99 provisions covering exceptions to such tariffs.
For further information to assist with the importation process, please refer to the frequently updated Cargo Systems Messaging Service (CSMS) messages at https://www.cbp.gov/trade/automated/cargo-systems-messaging-service and the Trade Remedies page at https://www.cbp.gov/trade/programs-administration/trade-remedies. The holding set forth above applies only to the specific factual situation and merchandise description as identified in the ruling request.
This position is clearly set forth in Title 19, Code of Federal Regulations (CFR), Section 177.9(b)(1).
The text above is an excerpt. The official ruling, with its letterhead, signature and any attachments, is on CBP CROSS (N360465).