The tariff classification of alloy steel pipes from South Korea
No revocation or modification of this ruling appears in the Customs Bulletin issues read here (Nov 6, 2024 through Nov 18, 2026), where CBP publishes most such actions. That is not confirmation that the ruling is still in effect. Confirm its status with CBP before relying on it (ruling on CBP CROSS).
Ruling text
In your letter dated April 6, 2026, you requested a tariff classification ruling on behalf of your client, Hyundai Steel Pipe America, Inc. The products under consideration are identified as door impact “beams,” BEAM-FR DR REINF, Model Number 76151. These hot-rolled electric resistance welded (ERW) alloy steel pipes are of a circular cross section and are manufactured for use inside doors of specific vehicle models.
You indicate that the pipes measure 31.8 mm in outside diameter and 2.6 mm in wall thickness and have been coated for surface treatment and rust prevention. Consideration was given to classifying the beams in subheading 8708.29, Harmonized Tariff Schedule of the United States (HTSUS), which provides for parts of vehicle bodies, as you suggested. We disagree. Classification of merchandise under the HTSUS is in accordance with the General Rules of Interpretation (GRI).
GRI 1 provides that classification is determined according to the terms of the headings and any relative section or chapter notes.
However, when classifying parts of a machine/vehicle it is also necessary to consider Additional U.S. Rule of Interpretation (AUSRI) 1(c), HTSUS, which reads “In the absence of special language or context which otherwise requires … a provision for parts of an article covers products solely or principally used as a part of such articles but a provision for “parts” or “parts and accessories” shall not prevail over a specific provision for such part or accessory.” The next step is to determine if a specific provision exists for the beams in question.
Heading 7306, HTSUS, provides for tubes, pipes and hollow profiles of iron or steel. In the condition as imported, the beams are straight length tubes that are not identifiable as motor vehicle components. The end use and final application of the beams do not negate this concept. As a result, classification of the beams in subheading 8708.29, HTSUS, is precluded.
To support classification in subheading 8708.29, HTSUS, you cite rulings HQ 084670, dated September 22, 1989, HQ 956790, dated October 28, 1994, and HQ 966623, dated June 21, 2004. In Ruling HQ 084670, the straight-cut lengths of mechanical tubing were classified in 7304, HTSUS, which are similar to the beams in question. It was the contour-cut length tubing that was classified in heading 8708, HTSUS.
In Ruling HQ 956790, the tubing was tapered to accept a mounted wheel bearing on one end and an axle carrier on the other end, and one end of each tube was tapered to make it smaller than the other end. As such, they were recognizable as automotive components and were classified as such in heading 8708, HTSUS. In Ruling HQ 966623, the straight-cut tubing was classified in heading 7306, HTSUS.
It stated that “[u]nlike the pipes in HQ 956790, the instant pipes are simple straight lengths of pipe.” The beams at issue resemble the pipes described in this ruling.
The text above is an excerpt. The official ruling, with its letterhead, signature and any attachments, is on CBP CROSS (N360469).