The tariff classification of wheeled propane tanker from Mexico
No revocation or modification of this ruling appears in the Customs Bulletin issues read here (Nov 6, 2024 through Nov 18, 2026), where CBP publishes most such actions. That is not confirmation that the ruling is still in effect. Confirm its status with CBP before relying on it (ruling on CBP CROSS).
Key passages, quoted from the ruling
- The applicable subheading for the propane tanker, schematic drawing LL740011000002, will be 8716.80.5090, Harmonized Tariff Schedule of the United States (HTSUS), which provides for “Trailers and semi-trailers; other vehicles, not mechanically propelled; and parts thereof: Other vehicles: Other: Other: Other.” The general rate of duty will be 3.2 percent ad valorem.
Ruling text
In your letter dated April 16, 2026, you requested a tariff classification ruling on behalf of your client, Triarc Tank, LLC, located in Dallas, Texas. The item under consideration has been identified as a tanker trailer, schematic drawing LL740011000002, that allows end-users to pump propane fluid through a secured coupling into the tank, which compresses the contents, allowing for the contents to be extracted from a dedicated service valve when desired.
You state that the tank pressure is monitored through a pressure gauge and can often be adjusted with a release valve and regulator. The precise suite of valves and gauge ports can be adjusted per customer specification. When shipped into the United States, the tanks consist of the tank body, the wheels, a suite of valves, and a tow lug attachment, which allows the tank to be towed at low speeds by an offroad motorized vehicle, tractor, or even by a beast of burden.
The tow lug attachment allows the propane to be transported and used in an off-road setting for applications such as: Heating various facilities (such as livestock housing) Powering certain machinery Drying harvested grains/crops; and Flame-clearing fields You state that because these propane trailers are mobile, they eliminate the need for separate propane tanks at each task location. The tanker trailers tanks are produced to the following industrial standard: ASME Section VIII, NFPA 58, NBIC.
The heads and shells of the tank portion of the propane trailer are produced from hot rolled coil (“HRC”), typically SA-414C (Carbon Steel); the tank heads are typically made from SA-285C HRC (Carbon Steel); and the shells are typically made from SA-455 HRC (Stainless Steel). The non-steel components consist of valves, gauges, coatings (epoxy primer, and polyester topcoat), weld wire, flux, and decals.
Depending upon the size, these tanker trailers weigh between 1,582 pounds (for a 250 Water Guage (WG) units) and 5,989 (for a 1000WG unit). The applicable subheading for the propane tanker, schematic drawing LL740011000002, will be 8716.80.5090, Harmonized Tariff Schedule of the United States (HTSUS), which provides for “Trailers and semi-trailers; other vehicles, not mechanically propelled; and parts thereof: Other vehicles: Other: Other: Other.” The general rate of duty will be 3.2 percent ad valorem.
The duties cited above are current as of this ruling’s issuance. Duty rates are provided for your convenience and are subject to change. The text of the most recent HTSUS and the accompanying duty rates are provided at https://hts.usitc.gov/. This ruling does not address the applicability of any additional duties, taxes, fees, exactions and/or other charges, which may apply to the goods discussed herein.
This includes, but is not limited to, tariffs and other duties as provided for in Subchapter III to Chapter 99, HTSUS. Thus, for example, in addition to the classification stated above, the merchandise covered by this ruling may also need to be reported with either the Chapter 99 provision under which an additional tariff applies or one of the Chapter 99 provisions covering exceptions to such tariffs.
The text above is an excerpt. The official ruling, with its letterhead, signature and any attachments, is on CBP CROSS (N360766).