The country of origin of valve cores
No revocation or modification of this ruling appears in the Customs Bulletin issues read here (Nov 6, 2024 through Nov 18, 2026), where CBP publishes most such actions. That is not confirmation that the ruling is still in effect. Confirm its status with CBP before relying on it (ruling on CBP CROSS).
Key passages, quoted from the ruling
- Thus, based on the totality of the circumstances, the country of origin of the valve cores will be Malaysia.
Ruling text
In your letter dated May 26, 2026, you requested a country of origin ruling on valve cores. The items under consideration are four red valve cores packaged together ready for retail sale (item number SP016). Each valve core functions as a tire valve that consists of a thimble, a core sleeve, a threaded head, a spring and a sealing ring. With respect to origin, each valve core is assembled in Malaysia using components from Malaysia and a spring ring from China.
Prior to final assembly, raw material (copper rods) undergoes machining to form a thimble, a core sleeve, and a threaded head. Afterwards, the thimble, the core sleeve and the threaded head are electroplated. For the spring from China, glue is applied and afterwards it is wound and electroplated. Final assembly involves inserting or screwing a thimble, a core sleeve, a threaded head, and a rubber seal, all manufactured in Malaysia, into one another. A spring is also installed.
The components are then pressed together, and two crimp/rivet points are used to secure the components. Lastly, each valve core is packaged on a blister card to complete item number SP016. When determining the country of origin for purposes of applying current trade remedies under Section 301 and additional duties, the substantial transformation analysis is applicable. See, e.g., Headquarters Ruling Letter H301619, dated November 6, 2018.
The test for determining whether a substantial transformation will occur is whether an article emerges from a process with a new name, character, or use different from that possessed by the article prior to processing. See Texas Instruments Inc. v. United States, 681 F.2d 778 (C.C.P.A. 1982). This determination is based on the totality of the evidence. See National Hand Tool Corp. v. United States, 16 C.I.T. 308 (1992), aff’d, 989 F.2d 1201 (Fed. Cir. 1993).
Additionally, Section 304 of the Tariff Act of 1930, as amended (19 U.S.C. 1304), provides that unless excepted, every article of foreign origin imported into the United States shall be marked in a conspicuous place as legibly, indelibly, and permanently as the nature of the article (or its container) will permit, in such a manner as to indicate to the ultimate purchaser in the United States, the English name of the country of origin of the article.
Congressional intent in enacting 19 U.S.C. 1304 was “that the ultimate purchaser should be able to know by an inspection of the marking on the imported goods the country of which the goods is the product. The evident purpose is to mark the goods so that at the time of purchase the ultimate purchaser may, by knowing where the goods were produced, be able to buy or refuse to buy them, if such marking should influence his will.” See United States v. Friedlaender & Co., 27 C.C.P.A. 297, 302 (1940).
Part 134 of the U.S. Customs and Border Protection (“CBP”) Regulations (19 CFR 134) implements the country of origin marking requirements and exceptions of 19 U.S.C. 1304. Section 134.1(b), CBP Regulations (19 CFR 134.1(b)), defines “country of origin” as the country of manufacture, production, or growth of any article of foreign origin entering the United States.
The text above is an excerpt. The official ruling, with its letterhead, signature and any attachments, is on CBP CROSS (N361779).