The country of origin of plunger pumps
No revocation or modification of this ruling appears in the Customs Bulletin issues read here (Nov 6, 2024 through Nov 18, 2026), where CBP publishes most such actions. That is not confirmation that the ruling is still in effect. Confirm its status with CBP before relying on it (ruling on CBP CROSS).
Key passages, quoted from the ruling
- Therefore, based on the totality of the circumstances, the country of origin of the subject pumps for scenarios one and two will be the UAE.
Ruling text
In your letter dated June 10, 2026, you requested a country of origin ruling on behalf of your client, Jereh Energy Equipment and Technologies Corporation. The articles at issue are referred to as plunger pumps, model numbers JR600, JR600N, JR600S, JR1000Q, JR1000QS, JR1600Q, JR2500QL, JR2500Q, JR2500HD, JR2800Q, JR2800HD, JR3500D, JR3500HD, JR4000HD, JR5000QPE, JR5000QPW, JR7000QPE and JR7000E.
The pumps, which feature 3 or 5 cylinders, continuously operate at 5600 horsepower and provide a maximum output of up to 7000 horsepower. The reciprocating linear motion of the plunger causes the expansion and contraction of the sealed cavity in the fluid end, realizing the suction and discharge of liquid. The gearbox transmits power to the crankshaft and other components.
The pump is used primarily in the oil exploration and development industry for oilfield exploitation, oil and gas field fracturing, and high-pressure fluid transportation. With respect to origin, two scenarios detail the final assembly of the plunger pump in the United Arab Emirates (UAE). In both scenarios, a fluid end subassembly and seven additional subassemblies are produced in the UAE and joined together. In the first scenario, these seven subassemblies are manufactured using raw materials from China.
In the second scenario, the seven subassemblies are produced using raw materials from China, South Korea, and Turkey. For the crankcase subassembly, oil holes undergo grinding and polishing processes to remove iron filings, burrs and flash. Bearings are disassembled and cleaned. Afterwards, the oil circuits are ground, polished, cleaned, and the plugs are tightened. A bearing retainer plate is then affixed to the lower end face of a bearing component, which is heated.
Once cooled, the assembly is fixed with the bearing retainer plate. Afterwards, cooled cylindrical pins are placed into the crankshaft. The upper and lower parts of a connecting rod assembly are mounted onto the crankshaft using positioning pins, and an adapter plate is installed on the lower connecting rod and secured in place using screws. A data cable and protective spring of a temperature sensor are compressed and press-fit into the connecting rod seat assembly.
Subsequently, outer rings of a bearing are cooled, installed onto the numbered crankcase bearing seats in sequence and fastened to outer rings with bolts. Bearing stoppers are installed using lock nuts and the outer ring of a bearing is interfaced onto the designated bearing seat and secured in place. Afterwards, a valve box is bolted to the crankcase, and the bores are machined to final dimensions. Using a press-fitting process, the end bearing shells are assembled onto the cast crosshead body.
For the crosshead housing subassembly, lifting lugs are assembled onto a crosshead housing, which is followed by the installation of cylindrical pins into the pin holes of a crosshead sliding sleeve. Afterwards, end bearing shells are press-fit onto the cast crosshead body, and a connecting rod bushing is installed into the pin hole of the connecting rod shank. Next, a crosshead pin is installed into the crosshead component and connecting rod small-end bushing.
The text above is an excerpt. The official ruling, with its letterhead, signature and any attachments, is on CBP CROSS (N362214).