The country of origin of electric salt and pepper grinders
No revocation or modification of this ruling appears in the Customs Bulletin issues read here (Nov 6, 2024 through Nov 18, 2026), where CBP publishes most such actions. That is not confirmation that the ruling is still in effect. Confirm its status with CBP before relying on it (ruling on CBP CROSS).
Key passages, quoted from the ruling
- Accordingly, the country of origin for the salt and pepper grinders will be China for the purposes of country of origin marking and applying the current trade remedies.
Ruling text
In your letter dated June 16, 2026, you requested a country of origin ruling for purposes of country of origin marking and applying current trade remedies. The merchandise under consideration includes an electric salt grinder and an electric pepper grinder (the “salt and pepper grinders” or “grinders”), which are identical in construction. The difference between the two grinders is limited to their use with salt or with pepper. Thus, the manufacturing process for the grinders in Taiwan is identical.
In your request, you note that the grinders would be assembled in Taiwan using components sourced from China and other components produced in Taiwan. The components sourced from China are the stainless steel upper section (referred to as the “SS upper housing”), which contains an electric motor and printed circuit board assembly (PCBA), thrust washer, spring, base plate, aluminum shaft, and coarseness adjustment knob.
The remaining components, i.e., plastic base, spindle support / centering bracket, retaining clip, adjustment rod, base locking insert, welded retaining ring, and stainless steel threaded insert, are made in Taiwan. The factory in Taiwan fabricates these components through the operations of plastic injection molding and metal machining.
The provided information indicates that China-origin components contribute approximately 84 percent of the total cost, with the stainless steel upper section alone accounting for roughly 74 percent. When determining the country of origin for purposes of applying current trade remedies under Section 301 and additional duties, the substantial transformation analysis is applicable. See, e.g., Headquarters Ruling Letter H301619, dated November 6, 2018.
The test for determining whether a substantial transformation will occur is whether an article emerges from a process with a new name, character, or use different from that possessed by the article prior to processing. See Texas Instruments Inc. v. United States, 681 F.2d 778 (C.C.P.A. 1982). This determination is based on the totality of the evidence. See National Hand Tool Corp. v. United States, 16 C.I.T. 308 (1992), aff’d, 989 F.2d 1201 (Fed. Cir. 1993).
Additionally, Section 304 of the Tariff Act of 1930, as amended (19 U.S.C. 1304), provides that unless excepted, every article of foreign origin imported into the United States shall be marked in a conspicuous place as legibly, indelibly, and permanently as the nature of the article (or its container) will permit, in such a manner as to indicate to the ultimate purchaser in the United States, the English name of the country of origin of the article.
Congressional intent in enacting 19 U.S.C. 1304 was “that the ultimate purchaser should be able to know by an inspection of the marking on the imported goods the country of which the goods is the product. The evident purpose is to mark the goods so that at the time of purchase the ultimate purchaser may, by knowing where the goods were produced, be able to buy or refuse to buy them, if such marking should influence his will.” See United States v. Friedlaender & Co., 27 C.C.P.A. 297, 302 (1940). Part 134 of the U.S.
The text above is an excerpt. The official ruling, with its letterhead, signature and any attachments, is on CBP CROSS (N362360).