The country of origin of electric marine propulsion systems from China
No revocation or modification of this ruling appears in the Customs Bulletin issues read here (Nov 6, 2024 through Nov 18, 2026), where CBP publishes most such actions. That is not confirmation that the ruling is still in effect. Confirm its status with CBP before relying on it (ruling on CBP CROSS).
Ruling text
In your letter dated June 16, 2026, you requested a country of origin ruling on electric marine propulsion systems. There are two items under consideration described as electric marine propulsion systems, identified by model numbers KAHE POD 600 and KAHE POD 160. KAHE POD 600 is designed to be attached to light watercrafts such as small boats, kayaks, float tubes and paddleboards to provide propulsion. It can also be converted as an underwater scooter for snorkeling.
This model is comprised of a main propulsion unit with a propeller, remote control, mounting kits for various watercrafts, and an underwater scooter conversion kit. KAHE POD 160 is a smaller unit designed to be attached to paddleboards and kayaks. It is comprised of a main propulsion unit with a propeller, remote control, and mounting kits. In your submission, you state that entire assembly process for both models takes place in France.
The main propulsion units are assembled in France using electric motors, battery, propeller, outer housing/enclosure of Chinese origin. All sub-assemblies are integrated using connectors, wires, and screws along with basic press-fitting. Once fully assembled and tested, the main propulsion unit is packaged with a remote control, charger, and mounting/conversion kits of Chinese origin for shipment to the United States. When determining the country of origin, the substantial transformation analysis is applicable.
See, e.g., Headquarters Ruling Letter (“HQ”) H301619, dated November 6, 2018. The test for determining whether a substantial transformation will occur is whether an article emerges from a process with a new name, character, or use different from that possessed by the article prior to processing. See Texas Instruments Inc. v. United States, 681 F.2d 778 (C.C.P.A. 1982). This determination is based on the totality of the evidence.
See National Hand Tool Corp. v. United States, 16 C.I.T. 308 (1992), aff’d, 989 F.2d 1201 (Fed. Cir. 1993).
Additionally, Section 304 of the Tariff Act of 1930, as amended (19 U.S.C. 1304), provides that unless excepted, every article of foreign origin imported into the United States shall be marked in a conspicuous place as legibly, indelibly, and permanently as the nature of the article (or its container) will permit, in such a manner as to indicate to the ultimate purchaser in the United States, the English name of the country of origin of the article.
Congressional intent in enacting 19 U.S.C. 1304 was “that the ultimate purchaser should be able to know by an inspection of the marking on the imported goods the country of which the goods is the product. The evident purpose is to mark the goods so that at the time of purchase the ultimate purchaser may, by knowing where the goods were produced, be able to buy or refuse to buy them, if such marking should influence his will.” See United States v. Friedlaender & Co., 27 C.C.P.A. 297, 302 (1940).
Part 134 of the U.S. Customs and Border Protection (“CBP”) Regulations (19 CFR 134) implements the country of origin marking requirements and exceptions of 19 U.S.C. 1304.
The text above is an excerpt. The official ruling, with its letterhead, signature and any attachments, is on CBP CROSS (N362361).