The tariff classification and country of origin of a turbo thruster kit
No Headquarters ruling in this index revokes or modifies this ruling. That is not confirmation that it is still in effect: this index does not hold every Headquarters ruling. Confirm its current status with CBP before relying on it (ruling on CBP CROSS). Text last read from CBP on Nov 21, 2026.
Key passages, quoted from the ruling
- The general rate of duty will be 2.3 percent ad valorem.
- Thus, based on the totality of the circumstances, the country of origin of turbocharger assembly will be Canada.
- Therefore, as the country of origin of the turbocharger assembly will be Canada, the country of origin of the turbo thruster kit for the purpose of duties will be Canada.
Ruling text
In your letter dated June 17, 2026, you requested a tariff classification and country of origin determination ruling for the purpose of marking and additional duties on behalf of your client, BD Engine Brake Inc. The item under consideration is the BD Diesel Turbo Thruster II Kit, part number 1047511. The kit is a complete automotive turbocharger assembly packaged with a silicone boot, a clamp, bolts and O-rings.
The turbocharger assembly, which imparts the essential character of the kit, primarily consists of a backplate, an aluminum compressor wheel, a compressor housing, a turbine housing and wheel, and features a rod end and a wastegate actuator. The turbocharger does not operate in excess of 35 pounds per square inch under normal conditions.
The applicable subheading for the turbo thruster kit will be 8414.59.3000, Harmonized Tariff Schedule of the United States (HTSUS), which provides for Air or vacuum pumps, air or other gas compressors and fans; ventilating or recycling hoods incorporating a fan, whether or not fitted with filters; gas-tight biological safety cabinets, whether or not fitted with filters; parts thereof: Fans: Other: Other: Turbochargers and superchargers. The general rate of duty will be 2.3 percent ad valorem.
With respect to origin, the final assembly occurs in Canada using components primarily from China and Canada, and a compressor wheel from Malaysia. Prior to the final assembly, a back plate recognizable as a finished back plate for a turbocharger is exported from China and imported into Canada to undergo machining processes. The machining processes finalize the geometric channels of the backplate. The final assembly process begins by installing a heat shield from China onto a bearing housing from China.
Afterwards, a piston ring is installed onto the shaft of a turbine wheel from China, which is followed by the installation of a journal bearing and a spacer. A second journal bearing is then placed onto the shaft of the turbine wheel. During the next step, the shaft is inserted into a bearing housing, and a turbine housing from China is bolted in place. Subsequently, a piston ring is installed onto an oil component that is afterwards inserted into a backplate.
A seal is then installed onto a backplate, and a thrust collar is inserted onto the shaft of a turbine. In the next step, the backplate is rotated, bolted in place and O-rings are installed. A compressor wheel from Malaysia and a compressor cover from China are installed and secured in place using a clamp plate and bolts. The process continues by securing a rod end from Canada onto the waste gate port with actuator clips, and then an actuator from China is inserted through the bracket of the compressor cover.
Lastly, a nut is installed and tightened onto the rod end. Grease and lubricant are applied throughout the assembly process.
The text above is an excerpt. The official ruling, with its letterhead, signature and any attachments, is on CBP CROSS (N362414).