The country of origin of a ball joint
No revocation or modification of this ruling appears in the Customs Bulletin issues read here (Nov 6, 2024 through Nov 18, 2026), where CBP publishes most such actions. That is not confirmation that the ruling is still in effect. Confirm its status with CBP before relying on it (ruling on CBP CROSS).
Ruling text
In your letter dated June 17, 2026, you requested a country of origin ruling on a ball joint for marking purposes and for purposes of applying trade remedies under Section 301 of the Trade Act of 1974, as amended, from China. The article under consideration is a cross axis ball joint (CABJ), Part Number 1044454-00-B / CCA0116, which is a precision component of a passenger-vehicle suspension.
The CABJ connects the control arm to the steering knuckle and is mounted inside the suspension link in place of a conventional rubber bushing. By increasing the lateral (transverse) stiffness of the link, it minimizes changes in suspension geometry and improves ride comfort and handling stability. During the vertical motion of the wheel (bump and rebound), the ball stud of the CABJ articulates (rotating and flexing) while transmitting load.
The CABJ therefore performs a core kinematic function of the suspension system. The CABJ is composed of the following seven components: pillow ball, boot, plug, lower clamp ring, upper clamp ring, and ball seat, all sourced from Korea, and socket housing from China. These components are joined into a single precision ball-joint mechanism through precision assembly and torque-verification processes performed in Korea.
When determining the country of origin for purposes of applying current trade remedies under Section 301 and additional duties, the substantial transformation analysis is applicable. See, e.g., Headquarters Ruling Letter H301619, dated November 6, 2018. The test for determining whether a substantial transformation will occur is whether an article emerges from a process with a new name, character, or use different from that possessed by the article prior to processing.
See Texas Instruments Inc. v. United States, 681 F.2d 778 (C.C.P.A. 1982). This determination is based on the totality of the evidence. See National Hand Tool Corp. v. United States, 16 C.I.T. 308 (1992), aff’d, 989 F.2d 1201 (Fed. Cir. 1993).
Additionally, Section 304 of the Tariff Act of 1930, as amended (19 U.S.C. 1304), provides that unless excepted, every article of foreign origin imported into the United States shall be marked in a conspicuous place as legibly, indelibly, and permanently as the nature of the article (or its container) will permit, in such a manner as to indicate to the ultimate purchaser in the United States, the English name of the country of origin of the article.
Congressional intent in enacting 19 U.S.C. 1304 was “that the ultimate purchaser should be able to know by an inspection of the marking on the imported goods the country of which the goods is the product. The evident purpose is to mark the goods so that at the time of purchase the ultimate purchaser may, by knowing where the goods were produced, be able to buy or refuse to buy them, if such marking should influence his will.” See United States v. Friedlaender & Co., 27 C.C.P.A. 297, 302 (1940).
Part 134 of the U.S. Customs and Border Protection (“CBP”) Regulations (19 CFR 134) implements the country of origin marking requirements and exceptions of 19 U.S.C. 1304.
The text above is an excerpt. The official ruling, with its letterhead, signature and any attachments, is on CBP CROSS (N362415).