The country of origin and marking of an electrical cable assembly
No revocation or modification of this ruling appears in the Customs Bulletin issues read here (Nov 6, 2024 through Nov 18, 2026), where CBP publishes most such actions. That is not confirmation that the ruling is still in effect. Confirm its status with CBP before relying on it (ruling on CBP CROSS).
Ruling text
In your letter dated June 21, 2026, you requested a country of origin and marking ruling on behalf of your client, Aerospace Lighting Corporation for an electrical cable assembly. The merchandise at issue is an electrical cable assembly, identified by part number 91620-0004. This is a wiring harness comprised of a multi-wire primary cable (base cable) bundled with other individually insulated wire conductors and then terminated at each end with specific connectors.
This electrical cable assembly is used to connect a printed circuit board inside a line replaceable unit (LRU). In aerospace and hardware engineering, an LRU is a self-contained component (like a radio or flight computer) that can be swapped out quickly for replacement or repair. The manufacturing process is described as follows. The U.S. origin base cable along with other insulated electrical wires are imported from Mexico and the United States to China.
Various contacts, heat-shrink tubing, and connectors are imported into China where the copper conductor wires are cut to length and the ends are stripped in preparation for the addition of the terminals and connectors. The terminals and connectors are then assembled onto the ends and the conductors are bundled together into the appropriate configuration. The assembly harnesses are then packaged for export to the United States.
When determining the country of origin for purposes of applying current trade remedies under Section 301 and additional duties, the substantial transformation analysis is applicable. See, e.g., Headquarters Ruling Letter H301619, dated November 6, 2018. The test for determining whether a substantial transformation will occur is whether an article emerges from a process with a new name, character, or use different from that possessed by the article prior to processing.
See Texas Instruments Inc. v. United States, 681 F.2d 778 (C.C.P.A. 1982). This determination is based on the totality of the evidence. See National Hand Tool Corp. v. United States, 16 C.I.T. 308 (1992), aff’d, 989 F.2d 1201 (Fed. Cir. 1993).
Additionally, Section 304 of the Tariff Act of 1930, as amended (19 U.S.C. 1304), provides that unless excepted, every article of foreign origin imported into the United States shall be marked in a conspicuous place as legibly, indelibly, and permanently as the nature of the article (or its container) will permit, in such a manner as to indicate to the ultimate purchaser in the United States, the English name of the country of origin of the article.
Congressional intent in enacting 19 U.S.C. 1304 was “that the ultimate purchaser should be able to know by an inspection of the marking on the imported goods the country of which the goods is the product. The evident purpose is to mark the goods so that at the time of purchase the ultimate purchaser may, by knowing where the goods were produced, be able to buy or refuse to buy them, if such marking should influence his will.” See United States v. Friedlaender & Co., 27 C.C.P.A. 297, 302 (1940).
Part 134 of the U.S. Customs and Border Protection (“CBP”) Regulations (19 CFR 134) implements the country of origin marking requirements and exceptions of 19 U.S.C.
The text above is an excerpt. The official ruling, with its letterhead, signature and any attachments, is on CBP CROSS (N362463).