The country of origin of a Pick & Hook Set
No revocation or modification of this ruling appears in the Customs Bulletin issues read here (Nov 6, 2024 through Nov 18, 2026), where CBP publishes most such actions. That is not confirmation that the ruling is still in effect. Confirm its status with CBP before relying on it (ruling on CBP CROSS).
Ruling text
In your submission dated June 22, 2026, you requested a country of origin ruling for purposes of Section 301 duties, other tariffs and marking. Pictures and descriptions of the manufacturing processes were included in your submission. The item under consideration is identified as a Pick & Hook Set, SKU# 48-22-9215. The set consists of four tools, each with a metal shaft with a specially shaped tip attached to a plastic handle.
These hand-operated tools are used for manual mechanical work, mainly to remove, pull, or position small parts such as O-rings, seals, clips, springs, and similar components in tight spaces. The user selects a hook or pick-shaped tool, inserts the tip into or around the part, and applies manual force through the handle to move or remove the component. The manufacturing process for each tool is identical.
It begins in Thailand, where Chinese-origin steel coil is straightened to ensure uniform flatness and is cut to the required lengths of the shaft. The cut steel piece undergoes precision machining operations to form the functional geometry of the tool shaft. This includes shaping one end of the shaft into a specific hook, angle, or pick profile that is required for functional engagement with components.
The shaft is further knurled to create textured patterns in order to improve grip retention and prevent slipping during use. The other end of the shaft is mechanically pressed to form the side wings that will attach to the plastic handle. The working end of the shaft is subsequently bent to the specific angle (e.g., 45°, 90°) to enable access into confined or obstructed spaces. The shaft is further shaped to ensure uniform diameter transitions and ergonomic geometry.
The shaft is then sent to China where it is heat treated, electroplated, and assembled with a Chinese-origin injection-molded plastic handle. When determining the country of origin for purposes of applying current trade remedies under Section 301 and additional duties, the substantial transformation analysis is applicable. See, e.g., Headquarters Ruling Letter H301619, dated November 6, 2018.
The test for determining whether a substantial transformation will occur is whether an article emerges from a process with a new name, character, or use different from that possessed by the article prior to processing. See Texas Instruments Inc. v. United States, 681 F.2d 778 (C.C.P.A. 1982). This determination is based on the totality of the evidence. See National Hand Tool Corp. v. United States, 16 C.I.T. 308 (1992), aff’d, 989 F.2d 1201 (Fed. Cir. 1993).
Additionally, Section 304 of the Tariff Act of 1930, as amended (19 U.S.C. 1304), provides that unless excepted, every article of foreign origin imported into the United States shall be marked in a conspicuous place as legibly, indelibly, and permanently as the nature of the article (or its container) will permit, in such a manner as to indicate to the ultimate purchaser in the United States, the English name of the country of origin of the article. Congressional intent in enacting 19 U.S.C.
The text above is an excerpt. The official ruling, with its letterhead, signature and any attachments, is on CBP CROSS (N362465).