The country of origin of a pry bar
No revocation or modification of this ruling appears in the Customs Bulletin issues read here (Nov 6, 2024 through Nov 18, 2026), where CBP publishes most such actions. That is not confirmation that the ruling is still in effect. Confirm its status with CBP before relying on it (ruling on CBP CROSS).
Ruling text
In your submission dated June 22, 2026, you requested a country of origin ruling for purposes of Section 301 duties, other tariffs and marking. Pictures and descriptions of the manufacturing processes were included in your submission. The item under consideration is identified as a pry bar, SKU 57721. It is a hand tool that incorporates a plastic handle attached to a steel shaft with a tapered working end and a nail-pulling slot.
The tool operates by applying manual force to create leverage, allowing the user to lift, separate, or remove materials and extract nails. The manufacturing process for the pry bar begins in Thailand, where Chinese-origin steel coil is straightened to ensure dimensional accuracy and is cut to the required lengths of the shaft. One end of the shaft is then pressed and formed into the tapered working end, excess material is removed, and the steel is machined to the required dimensions and profile.
The other end of the shaft is mechanically pressed to form the side wings/flanges that will attach to the plastic handle. The working end of the shaft is subsequently bent to the required angle to create the leverage geometry necessary for the pry bar’s intended function. Product identification and branding are permanently pressed into the shaft before it is polished to remove burrs and surface imperfections.
The shaft is then sent to China where it is heat treated, electroplated and assembled with a Chinese-origin injection-molded plastic handle. When determining the country of origin for purposes of applying current trade remedies under Section 301 and additional duties, the substantial transformation analysis is applicable. See, e.g., Headquarters Ruling Letter H301619, dated November 6, 2018.
The test for determining whether a substantial transformation will occur is whether an article emerges from a process with a new name, character, or use different from that possessed by the article prior to processing. See Texas Instruments Inc. v. United States, 681 F.2d 778 (C.C.P.A. 1982). This determination is based on the totality of the evidence. See National Hand Tool Corp. v. United States, 16 C.I.T. 308 (1992), aff’d, 989 F.2d 1201 (Fed. Cir. 1993).
Additionally, Section 304 of the Tariff Act of 1930, as amended (19 U.S.C. 1304), provides that unless excepted, every article of foreign origin imported into the United States shall be marked in a conspicuous place as legibly, indelibly, and permanently as the nature of the article (or its container) will permit, in such a manner as to indicate to the ultimate purchaser in the United States, the English name of the country of origin of the article.
Congressional intent in enacting 19 U.S.C. 1304 was “that the ultimate purchaser should be able to know by an inspection of the marking on the imported goods the country of which the goods is the product. The evident purpose is to mark the goods so that at the time of purchase the ultimate purchaser may, by knowing where the goods were produced, be able to buy or refuse to buy them, if such marking should influence his will.” See United States v. Friedlaender & Co., 27 C.C.P.A. 297, 302 (1940). Part 134 of the U.S.
The text above is an excerpt. The official ruling, with its letterhead, signature and any attachments, is on CBP CROSS (N362466).