The country of origin of a USB-C to Gigabit Ethernet Adapter
No revocation or modification of this ruling appears in the Customs Bulletin issues read here (Nov 6, 2024 through Nov 18, 2026), where CBP publishes most such actions. That is not confirmation that the ruling is still in effect. Confirm its status with CBP before relying on it (ruling on CBP CROSS).
Ruling text
In your letter dated June 24, 2026, you requested a country of origin ruling on a USB-C to Gigabit Ethernet Adapter. The item concerned is identified as a USBC to Gigabit Ethernet Adapter, Item No. CT-530 (CT-530). The item is described as a short cable, enclosed in an aluminum housing, with a USB-C connector on one end and an RJ45 port connected to the other end. The manufacturing process begins in Taiwan with the production of the printed circuit board assembly (PCBA).
The main component is called the ASIX Electronics AX88179B chipset, which is sourced from ASIX Electronics, a Taiwanese integrated circuit (IC) design company. Other passive electronic components, such as resistors, capacitors, etc., are sourced from Korea, China, and Taiwan. A laser-cut stainless steel stencil is prepared for the printed circuit board (PCB) layout. Solder paste is printed onto the PCB pads through the stencil. The ASIX chipset and other electronic components are placed onto the bare PCB.
The board passes through a reflow oven, permanently soldering all components onto the board, forming a completed PCBA. The completed PCBA is shipped to China where a short cable is soldered onto the PCBA. A plastic end piece on the cable allows the aluminum housing to be fitted over the PCBA and clamped shut. The unit then goes through functional and visual testing. The finished product is shipped back to Taiwan for final inspection and packaging for importation into the United States.
Section 304 of the Tariff Act of 1930, as amended (19 U.S.C. 1304), provides that unless excepted, every article of foreign origin imported into the United States shall be marked in a conspicuous place as legibly, indelibly, and permanently as the nature of the article (or its container) will permit, in such a manner as to indicate to the ultimate purchaser in the United States, the English name of the country of origin of the article.
Congressional intent in enacting 19 U.S.C. 1304 was “that the ultimate purchaser should be able to know by an inspection of the marking on the imported goods the country of which the goods is the product. The evident purpose is to mark the goods so that at the time of purchase the ultimate purchaser may, by knowing where the goods were produced, be able to buy or refuse to buy them, if such marking should influence his will.” See United States v. Friedlaender & Co., 27 C.C.P.A. 297, 302 (1940).
Part 134 of the U.S. Customs and Border Protection (“CBP”) Regulations (19 CFR 134) implements the country of origin marking requirements and exceptions of 19 U.S.C. 1304. Section 134.1(b), CBP Regulations (19 CFR 134.1(b)), defines “country of origin” as the country of manufacture, production, or growth of any article of foreign origin entering the United States.
Further work or material added to an article in another country must effect a substantial transformation in order to render such other country the “country of origin” within the meaning of the marking laws and regulations.
The text above is an excerpt. The official ruling, with its letterhead, signature and any attachments, is on CBP CROSS (N362527).