The country of origin of an 18" Indexing Flat Pry Bar
No revocation or modification of this ruling appears in the Customs Bulletin issues read here (Nov 6, 2024 through Nov 18, 2026), where CBP publishes most such actions. That is not confirmation that the ruling is still in effect. Confirm its status with CBP before relying on it (ruling on CBP CROSS).
Ruling text
In your letter dated June 26, 2026, you requested a country of origin determination for purposes of Section 301 and other duties. Pictures of the item in different stages of manufacture were included with your submission, along with a narrative of the manufacturing processes. The merchandise is identified as an 18" Indexing Flat Pry Bar. It is a hand tool constructed from carbon steel that is used for prying, lifting and separating materials, and removing nails.
It is constructed with a rotatable claw-shaped head that can swivel 180 degrees and lock at 16 positions by pressing an indexing gear located on the side of the claw. The tool also incorporates a raised striking surface and narrow jab end to provide strong leverage for prying materials and pulling nails. The tool has a length of 18 inches and weighs 2.20 pounds. You propose two manufacturing scenarios.
The first scenario begins in Vietnam, where carbon steel is forged into a flat rough shape of the claw head of the tool. This article is then sent to China, where it is further forged and bent into its final claw-shaped angle head of the pry bar. A V-shaped notch is machined into the claw for the nail puller slot and holes are drilled into it for assembly with the handle and an indexing gear.
Teeth are then milled into one of the holes, to allow the indexing gear to swivel the head and lock it into position once assembled. Further in China, the metal handle is forged, drilled with assembly holes and milled with teeth for assembly with an indexing gear and the claw head. The handle and the claw also undergo quenching, tempering, sandblasting, and electrophoretic coating. Finally, the handle and claw are assembled with a Chinese origin indexing gear, end cap, spring, and plastic handle grip.
The second manufacturing scenario is similar to the first, except a rough shape of the handle is forged in Vietnam. It is then sent to China, along with the flat rough shape of the claw head, where it is drilled with assembly holes and milled with teeth for assembly with a Chinese-origin indexing gear and the final claw shaped head. When determining the country of origin for purposes of applying current trade remedies under Section 301 and additional duties, the substantial transformation analysis is applicable.
See, e.g., Headquarters Ruling Letter H301619, dated November 6, 2018. The test for determining whether a substantial transformation will occur is whether an article emerges from a process with a new name, character, or use different from that possessed by the article prior to processing. See Texas Instruments Inc. v. United States, 681 F.2d 778 (C.C.P.A. 1982). This determination is based on the totality of the evidence.
See National Hand Tool Corp. v. United States, 16 C.I.T. 308 (1992), aff’d, 989 F.2d 1201 (Fed. Cir. 1993). In regard to your manufacturing scenarios, there is no dispute that the rough shapes of the claw head and handle, which are produced in Vietnam, are dedicated for use in the finished flat indexing pry bar. In other words, they have a pre-determined use at the time they are exported from Vietnam to China.
The text above is an excerpt. The official ruling, with its letterhead, signature and any attachments, is on CBP CROSS (N362606).