The tariff classification of a steel compression limiter from China
No Headquarters ruling in this index revokes or modifies this ruling. That is not confirmation that it is still in effect: this index does not hold every Headquarters ruling. Confirm its current status with CBP before relying on it (ruling on CBP CROSS). Text last read from CBP on Nov 21, 2026.
Key passages, quoted from the ruling
- The applicable subheading for the compression limiter will be 7318.29.0000, HTSUS, which provides for Screws, bolts, nuts, coach screws, screw hooks, rivets, cotters, cotter pins, washers (including spring washers) and similar articles, of iron or steel: Non-threaded articles: Other.
Ruling text
In your letter dated July 7, 2026, you requested a tariff classification ruling. Photographs and descriptions of the merchandise were included in your inquiry. The article under consideration is described as a compression limiter, part number PINSS093F. It is a cylindrical steel component with an oval inner hole and a knurled outer edge that is used in conjunction with a bolt or screw as part of a fastening system.
This compression limiter is designed for and used exclusively on an alternator splash shield cover for a specific motor vehicle and functions as a sleeve or spacer. It is pressed into place in the plastic cover and secured by a flanged hex head bolt. The bolt head clamps against the compression limiter instead of directly on the plastic.
When the sleeve is fully compressed between the mounting surfaces, tightening stops increasing the load on the plastic, thereby protecting the plastic from being crushed, creeping over time, or cracking while maintaining consistent clamp force. You state that its primary purpose is to: 1) limit the compression of plastic or composite materials when a fastener is tightened; 2) maintain consistent clamping force within an assembly; and 3) prevent deformation or damage to the surrounding material.
You suggested that this item could be classified under subheading 8708.29.51.60, Harmonized Tariff Schedule of the United States (HTSUS), which provides for Parts and accessories of the motor vehicles of heading 8701 to 8705: Other parts and accessories of bodies (including cabs): Other: Other: Other. We disagree. Classification of merchandise under the HTSUS is governed by the General Rules of Interpretation (GRIs) taken in order.
GRI 1 provides that the classification is determined first in accordance with the terms of the headings and any relative section and chapter notes. Note 2(b) to Section XVII, which includes Chapter 87, provides that if the article is classifiable as a “part of general use” of base metal, classification as a part or accessory in heading 8708 is precluded. "Parts of general use" are defined in Note 2, Section XV, HTSUS, among other things, base metal articles of heading 7318, HTSUS.
Heading 7318 includes, in pertinent part, Screws, bolts, nuts, coach screws, screw hooks, rivets, cotters, cotter pins, washers (including spring washers) and similar articles, of iron or steel. In addition, the Explanatory Notes (EN) to Section XV provide that in general, identifiable parts of articles are classified as such parts in their appropriate headings in the Nomenclature.
However, “parts of general use” presented separately are not considered as parts of articles but are classified in the headings of this Section appropriate to them. This applies even if the component has a limited or specialized function. We find that the subject compression limiter meets the definition of a base metal fastener and is more specifically provided for in heading 7318, HTSUS.
As such, it is considered a “part of general use” per Note 2(a) to Section XV and is precluded from classification in heading 8708, HTSUS.
The text above is an excerpt. The official ruling, with its letterhead, signature and any attachments, is on CBP CROSS (N362924).