The tariff classification of a portable reading stand from India
No revocation or modification of this ruling appears in the Customs Bulletin issues read here (Nov 6, 2024 through Nov 18, 2026), where CBP publishes most such actions. That is not confirmation that the ruling is still in effect. Confirm its status with CBP before relying on it (ruling on CBP CROSS).
Key passages, quoted from the ruling
- The applicable subheading for the portable reading stand will be 7326.90.8688, HTSUS, which provides for “Other articles of iron or steel: Other: Other: Other: Other: Other.” The general rate of duty will be 2.9 percent ad valorem.
Ruling text
In your letter dated July 9, 2026, you requested a tariff classification ruling. Informational material was submitted with your request. The item under consideration is a portable reading stand. The stand consists of a stainless steel base plate and a stainless steel support arm which are joined together by hinges allowing them to fold together for portability or fold out for use.
The support arm is approximately 1 inch wide by 6.75 inches in length, and the base plate is 4.5 inches by 3.75 inches on one end tapering down to 1 inch in width on the other where it is attached to the support arm. When in use the base plate rests on a flat surface, the support arm folds out at a 45-degree angle and slides into a spine sleeve of a specially designed book cover, which is not included, allowing the user to read and study the book at an elevated angle.
In your submission, you propose classification of the reading stand under subheading 8304.00.0000, Harmonized Tariff Schedule of the United States (HTSUS), as office or desk equipment of a base metal. We disagree. CBP has long held that the essential character of articles of heading 8304, HTSUS, is that they are used to hold desk or office articles such as paper, pens, and office stamps. See Headquarters Ruling Letter H014942, dated October 17, 2007.
We note that the reading stand under consideration is portable and only functions with a compatible sleeve-equipped book cover. The stand can be used on a table or flat surface in any location, including in a restaurant, when traveling, etc. It is not akin to the exemplars of heading 8304, HTSUS, thus it is precluded from classification as office or desk equipment of a base metal.
Heading 7326, HTSUS, is a residual or basket provision which covers a wide range of iron or steel articles that are not more specifically provided for elsewhere in the HTSUS.
The Explanatory Notes (ENs) to heading 7326, HTSUS, state that “This heading covers all iron or steel articles obtained by forging or punching, by cutting or stamping or by other processes such as folding, assembling, welding, turning, milling or perforating other than articles included in the preceding headings of this Chapter or covered by Note 1 to Section XV or included in Chapter 82 or 83 or more specifically covered elsewhere in the Nomenclature.” An article of iron or steel can be classified in heading 7326, HTSUS, if it is determined that the item is not more specifically provided for in any other heading of the tariff.
The portable reading stand is not specifically covered elsewhere in the tariff. Accordingly, it is classifiable in heading 7326, HTSUS. The applicable subheading for the portable reading stand will be 7326.90.8688, HTSUS, which provides for “Other articles of iron or steel: Other: Other: Other: Other: Other.” The general rate of duty will be 2.9 percent ad valorem. The duties cited above are current as of this ruling’s issuance. Duty rates are provided for your convenience and are subject to change.
The text of the most recent HTSUS and the accompanying duty rates are provided at https://hts.usitc.gov/.
The text above is an excerpt. The official ruling, with its letterhead, signature and any attachments, is on CBP CROSS (N363004).