The country of origin of origin of a basin wrench
No revocation or modification of this ruling appears in the Customs Bulletin issues read here (Nov 6, 2024 through Nov 18, 2026), where CBP publishes most such actions. That is not confirmation that the ruling is still in effect. Confirm its status with CBP before relying on it (ruling on CBP CROSS).
Ruling text
In your letter dated July 30, 2026, you requested a country of origin determination for purposes of Section 301, other duties and marking. Pictures and descriptions of the manufacturing processes were included in your submission The product under consideration is a basin wrench. It is a plumbing tool used in confined spaces, such as underneath kitchen and bath sinks, to turn fasteners and pipes. The tool consists of an extendable shaft that is attached to a lower jaw.
The metal shaft is made of steel and is comprised of two pieces, one inside the other, that slide out to extend the reach of the wrench. The inner part of the shaft attaches to the lower jaw with a pivot pin. The pivot pin enables the jaw assembly to rotate around its axis perpendicular to the shaft. A spring-loaded curved jaw is attached to the lower jaw with an additional pivot pin. Both jaws incorporate teeth for better gripping power. A handle fits through a hole at the other end of the extendable shaft.
You have stated that the basin wrench will be produced in Thailand and China. In Thailand, raw steel rods are drop forged to make the jaw blanks of the lower jaw and curved jaw. The inner piece of the extendable shaft is also made in Thailand from raw steel stock. These three components are further die-cut, deburred, and sandblasted before being sent to China. Upon arrival in China, the jaws are machined to add teeth, holes are drilled in each piece, and all components are heat treated.
The Thailand-origin inner shaft is then assembled with a Chinese-origin outer shaft piece. The jaws and extendable shaft are further assembled with Chinese-origin springs, pins, clips, and a handle. Finally, the completed basin wrench is packaged for retail sale and exported to the United States. When determining the country of origin for purposes of applying current trade remedies under Section 301 and additional duties, the substantial transformation analysis is applicable.
See, e.g., Headquarters Ruling Letter H301619, dated November 6, 2018. The test for determining whether a substantial transformation will occur is whether an article emerges from a process with a new name, character, or use different from that possessed by the article prior to processing. See Texas Instruments Inc. v. United States, 681 F.2d 778 (C.C.P.A. 1982). This determination is based on the totality of the evidence.
See National Hand Tool Corp. v. United States, 16 C.I.T. 308 (1992), aff’d, 989 F.2d 1201 (Fed. Cir. 1993).
Additionally, Section 304 of the Tariff Act of 1930, as amended (19 U.S.C. 1304), provides that unless excepted, every article of foreign origin imported into the United States shall be marked in a conspicuous place as legibly, indelibly, and permanently as the nature of the article (or its container) will permit, in such a manner as to indicate to the ultimate purchaser in the United States, the English name of the country of origin of the article.
Congressional intent in enacting 19 U.S.C. 1304 was “that the ultimate purchaser should be able to know by an inspection of the marking on the imported goods the country of which the goods is the product.
The text above is an excerpt. The official ruling, with its letterhead, signature and any attachments, is on CBP CROSS (N363856).