The country of origin of wheel hub units
No revocation or modification of this ruling appears in the Customs Bulletin issues read here (Nov 6, 2024 through Nov 18, 2026), where CBP publishes most such actions. That is not confirmation that the ruling is still in effect. Confirm its status with CBP before relying on it (ruling on CBP CROSS).
Ruling text
In your letter dated July 31, 2026, you requested a country of origin ruling on wheel hub units, which you filed on behalf of Motorcar Parts of America, Inc. The articles under consideration are wheel hub units incorporating either ball bearings or tapered roller bearings. Parts WH515096, DLG515096, and A515096 incorporate splined inner flanges. The spline feature allows the hub to mesh with the drive axle and transmit torque.
Part WH515054 is a non-splined unit, where the bearing/hub assemblies do not contain internal splined teeth that engage a drive axle to transmit torque. Each wheel hub unit mainly consists of an inner flange, outer flange, inner rings, cage, tapered rollers (or balls), anti-lock braking system (ABS) sensor, screws, tooth ring, shim, seals, and bolts of Chinese origin. The inner rings, outer flange, and inner flange are sourced from China in a raw, unfinished form and sent to Malaysia for further processing.
The remaining components are not subject to any further processes in Malaysia and will be incorporated into the wheel hub units in the condition as imported. In Malaysia, the inner rings undergo grinding, superfine grinding, and auto-matching.
The flanges undergo computer numerical control (CNC) lathe machining, bolt installation, grease application, seal installation, bearing set pressing, roll form (riveting), crack testing, examination, cap pressing, retainer installation, ABS sensor installation, internal End of Line (EOL) testing, voltage testing, spline broaching (for Parts WH515056, DLG515096, and A515096), anti-rust application, laser etching, and durability testing. Finally, the products are packaged and labeled ready for shipment.
When determining the country of origin, the substantial transformation analysis is applicable. See, e.g., Headquarters Ruling Letter (“HQ”) H301619, dated November 6, 2018. The test for determining whether a substantial transformation will occur is whether an article emerges from a process with a new name, character, or use different from that possessed by the article prior to processing. See Texas Instruments Inc. v. United States, 681 F.2d 778 (C.C.P.A. 1982).
This determination is based on the totality of the evidence. See National Hand Tool Corp. v. United States, 16 C.I.T. 308 (1992), aff’d, 989 F.2d 1201 (Fed. Cir. 1993). In the instant case, the flanges and rings from China are dedicated for use in the finished wheel hub unit. Thus, the components have a pre-determined use at the time of exportation from China.
In National Hand Tool, the Court of International Trade determined the country of origin marking requirements for imported individual tools which were used to produce flex sockets, speeder handles and flex handles. The court found that the character of the tools remained unchanged after heat-treatment, electroplating and assembly, and the form of the components remained the same since each component was either hot-forged or cold-forged into its final shape in Taiwan.
The text above is an excerpt. The official ruling, with its letterhead, signature and any attachments, is on CBP CROSS (N363919).