The tariff classification of a sword holder from Canada
No Headquarters ruling in this index revokes or modifies this ruling. That is not confirmation that it is still in effect: this index does not hold every Headquarters ruling. Confirm its current status with CBP before relying on it (ruling on CBP CROSS). Text last read from CBP on Nov 21, 2026.
Key passages, quoted from the ruling
- The applicable subheading for the sword and scabbard holder will be 4420.90.8000, Harmonized Tariff Schedule of the United States (HTSUS), which provides for Wood marquetry and inlaid wood; caskets and cases for jewelry or cutlery and similar articles, of wood; statuettes and other ornaments, of wood; wooden articles of furniture not falling within chapter 94: Other: Other.
- The general rate of duty will be 3.2 percent ad valorem.
Ruling text
In your letter, dated September 9, 2026, you requested a binding tariff classification ruling on a sword and scabbard holder. Product information and photos were submitted for our review. The product under consideration is identified as a wall-mounted sword and scabbard support, retention and display fixture. The fixture measures approximately 42" tall x 12" wide x 3/4" thick.
The fixture is manufactured from a walnut (a non-coniferous wood) edge-glued lumber plaque that is grooved over most of its surface with a decorative lined design, and is fitted with four iron rings attached to leather loops. The two upper leather loops hold the crossguard of the sword and the lower leather loop holds the blade in its scabbard. The leather loops hold the sword and scabbard against the walnut board so as to look like the sword and scabbard are mounted on a wooden plaque.
The sword and scabbard are not imported with the display fixture. The display fixture is predominantly wood and the metal rings and leather loops comprise a very small portion of the fixture. Therefore, the fixture will be classified by the wood portion.
The applicable subheading for the sword and scabbard holder will be 4420.90.8000, Harmonized Tariff Schedule of the United States (HTSUS), which provides for Wood marquetry and inlaid wood; caskets and cases for jewelry or cutlery and similar articles, of wood; statuettes and other ornaments, of wood; wooden articles of furniture not falling within chapter 94: Other: Other. The general rate of duty will be 3.2 percent ad valorem.
This ruling does not address the applicability of any additional duties, taxes, fees, exactions and/or other charges, which may apply to the goods discussed herein. This includes, but is not limited to, tariffs and other duties as provided for in Subchapter III to Chapter 99, HTSUS.
Thus, for example, in addition to the classification stated above, the merchandise covered by this ruling may also need to be reported with either the Chapter 99 provision under which an additional tariff applies or one of the Chapter 99 provisions covering exceptions to such tariffs.
For further information to assist with the importation process, please refer to the frequently updated Cargo Systems Messaging Service (CSMS) messages at https://www.cbp.gov/trade/automated/cargo-systems-messaging-service and the Trade Remedies page at https://www.cbp.gov/trade/programs-administration/trade-remedies. The holding set forth above applies only to the specific factual situation and merchandise description as identified in the ruling request.
This position is clearly set forth in Title 19, Code of Federal Regulations (CFR), Section 177.9(b)(1). This section states that a ruling letter is issued on the assumption that all of the information furnished in the ruling letter, whether directly, by reference, or by implication, is accurate and complete in every material respect. In the event that the facts are modified in any way, or if the goods do not conform to these facts at time of importation, you should bring this to the attention of U.S.
The text above is an excerpt. The official ruling, with its letterhead, signature and any attachments, is on CBP CROSS (N364932).