The country of origin of an automotive headlight switch assembly
No Headquarters ruling in this index revokes or modifies this ruling. That is not confirmation that it is still in effect: this index does not hold every Headquarters ruling. Confirm its current status with CBP before relying on it (ruling on CBP CROSS). Text last read from CBP on Nov 21, 2026.
Ruling text
In your letter dated September 27, 2026, you requested a country of origin ruling. The item under consideration in this request is an automotive headlight switch assembly, model number KD-2002, which is a multi-function switch assembly used to control a vehicle’s headlights and instrument illumination intensity level.
The automotive headlight switch assembly is installed in close proximity to the driver’s seating position in a vehicle for the purpose of adjusting the vehicle’s instrument panel illumination intensity level and selecting the exterior lighting such as headlights OFF, headlights ON, headlights AUTO ON/OFF, and parking lamps only ON. In Thailand, electronic components such as resistors, diodes, and LEDs are assembled onto a bare printed circuit board via surface mount technology (SMT).
In Thailand, with components sourced from China and Thailand, the PCBA is further assembled into a plastic housing with other switch components including electrical contacts, springs, and mechanical components such as a Rotary Knob and Rotary Wiper Contacts to make a complete automotive headlight switch assembly. The finished assembly is inspected, tested, and packaged for export to the United States.
When determining the country of origin for purposes of applying current trade remedies under Section 301and additional duties, the substantial transformation analysis is applicable. See, e.g., Headquarters Ruling Letter H301619, dated November 6, 2018. The test for determining whether a substantial transformation will occur is whether an article emerges from a process with a new name, character, or use different from that possessed by the article prior to processing.
See Texas Instruments Inc. v. United States, 681 F.2d 778 (C.C.P.A. 1982). This determination is based on the totality of the evidence. See National Hand Tool Corp. v. United States, 16 C.I.T. 308 (1992), aff’d, 989 F.2d 1201 (Fed. Cir. 1993).
Additionally, Section 304 of the Tariff Act of 1930, as amended (19 U.S.C. 1304), provides that unless excepted, every article of foreign origin imported into the United States shall be marked in a conspicuous place as legibly, indelibly, and permanently as the nature of the article (or its container) will permit, in such a manner as to indicate to the ultimate purchaser in the United States, the English name of the country of origin of the article.
Congressional intent in enacting 19 U.S.C. 1304 was “that the ultimate purchaser should be able to know by an inspection of the marking on the imported goods the country of which the goods is the product. The evident purpose is to mark the goods so that at the time of purchase the ultimate purchaser may, by knowing where the goods were produced, be able to buy or refuse to buy them, if such marking should influence his will.” See United States v. Friedlaender & Co., 27 C.C.P.A. 297, 302 (1940).
Part 134 of the U.S. Customs and Border Protection (“CBP”) Regulations (19 CFR 134) implements the country of origin marking requirements and exceptions of 19 U.S.C. 1304.
The text above is an excerpt. The official ruling, with its letterhead, signature and any attachments, is on CBP CROSS (N365444).