The tariff classification of helical coil springs from Germany
No revocation or modification of this ruling appears in the Customs Bulletin issues read here (Nov 6, 2024 through Nov 18, 2026), where CBP publishes most such actions. That is not confirmation that the ruling is still in effect. Confirm its status with CBP before relying on it (ruling on CBP CROSS).
Key passages, quoted from the ruling
- Therefore, the applicable subheading for the helical coil springs will be 7320.20.1000, HTSUS, which provides for “Springs and leaves for springs, of iron or steel: Suitable for motor-vehicle suspension.” The general rate of duty will be 3.2 percent ad valorem.
Ruling text
In your letter dated September 28, 2026, you requested a tariff classification ruling. Informational material was submitted with your request. The product under consideration is a set of helical coil springs identified as the “Eibach Pro-Kit.” This set includes two pairs of helical coil springs made of steel wires that are 13 millimeters (mm) to 15 mm thick and designed to function as the suspension for the 2000 BMW 5-Series E39 Touring Wagon.
One pair of springs is for the front axle, and the other pair is for the rear axle. The dimensions and versions of the springs in this kit depend on the axle load and engine type. The springs for the front axle cover a diameter of 175 mm to 182 mm and can have untensioned lengths greater than 260 mm. The springs for the rear axle cover a diameter of 110 mm to 118 mm and have untensioned lengths greater than 315 mm.
General Rule of Interpretation (GRI) 1 states “classification shall be determined according to the terms of the headings and any relative section or chapter.” The provided information indicates the subject springs are made of steel and are appropriately classified under Chapter 73, Harmonized Tariff Schedule of the United States (HTSUS), which provides for “Articles of Iron or Steel.” In this chapter, there is a subheading that specifically covers helical springs that are suitable for motor-vehicle suspension, 7320.20.1000, HTSUS.
Therefore, the applicable subheading for the helical coil springs will be 7320.20.1000, HTSUS, which provides for “Springs and leaves for springs, of iron or steel: Suitable for motor-vehicle suspension.” The general rate of duty will be 3.2 percent ad valorem. The duties cited above are current as of this ruling’s issuance. Duty rates are provided for your convenience and are subject to change. The text of the most recent HTSUS and the accompanying duty rates are provided at https://hts.usitc.gov/.
This ruling does not address the applicability of any additional duties, taxes, fees, exactions and/or other charges, which may apply to the goods discussed herein. This includes, but is not limited to, tariffs and other duties as provided for in Subchapter III to Chapter 99, HTSUS.
Thus, for example, in addition to the classification stated above, the merchandise covered by this ruling may also need to be reported with either the Chapter 99 provision under which an additional tariff applies or one of the Chapter 99 provisions covering exceptions to such tariffs.
For further information to assist with the importation process, please refer to the frequently updated Cargo Systems Messaging Service (CSMS) messages at https://www.cbp.gov/trade/automated/cargo-systems-messaging-service and the Trade Remedies page at https://www.cbp.gov/trade/programs-administration/trade-remedies. The holding set forth above applies only to the specific factual situation and merchandise description as identified in the ruling request.
This position is clearly set forth in Title 19, Code of Federal Regulations (CFR), Section 177.9(b)(1).
The text above is an excerpt. The official ruling, with its letterhead, signature and any attachments, is on CBP CROSS (N365455).